Tuning of electronic properties of co-evaporated Ag:SnS thin films for heterojunction devices

Neju Mathew Philip,M. C. Santhosh Kumar
DOI: https://doi.org/10.1007/s10854-024-12078-6
2024-02-14
Journal of Materials Science Materials in Electronics
Abstract:Co-evaporation method was used to deposit Ag-doped SnS thin films on soda lime glass substrates at 300 °C. The Ag doping concentration was systematically varied in the range of 0 to 9 wt% of SnS. The effect of Ag doping concentration on the morphological, structural, optical and electrical properties of the as-deposited films has been investigated. SEM and AFM studies showed that the surface morphology is influenced significantly by Ag doping and the surface roughness decreased from 97 nm to 59 nm with an increase in Ag doping level. The existence of Sn, S, and Ag in the deposited films was confirmed by Energy Dispersive Spectroscopy. The formation of SnS without the presence of any impurity phases was confirmed by XRD measurements and Raman analysis. The optical bandgap decreases from 1.97 to 1.83 eV with the increase in Ag doping. The electrical studies revealed that all the deposited films demonstrated p-type conductivity. A significant increase in mobility from 197 to 1360 cm 2 V −1 s −1 was observed upon the increase in the doping concentration of Ag. Heterojunction devices were fabricated with 9% Ag:SnS thin film as the p-type layer and RF sputtered Al:ZnO thin film as the n-layer on the FTO substrate. The knee voltage of the diode was 0.9 V with an ideality factor of 8.7 and a rectification ratio of 23.9 at ± 2 V.
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied
What problem does this paper attempt to address?