Optimizing the structure and optoelectronic properties of cuprite thin films via a plasma focus device as a solar cell absorber layer

Ahmed M. Hassan,Haifa A. Alyousef,Hesham M. H. Zakaly

DOI: https://doi.org/10.1039/d3ce01237a

IF: 3.756

2024-02-23

CrystEngComm

Abstract:Solar cells are of growing importance as a renewable energy source, and cuprite (Cu 2 O) stands out as a promising material due to its cost-effectiveness, abundance, and appealing optoelectronic characteristics. This research uses diverse analytical methods to adjust the influence of the number of plasma focus shots on Cu 2 O films' crystal structure, morphology, and optoelectronic attributes. X-ray diffraction revealed that both Cu 2 O and CuO films exhibited a polycrystalline nature with cubic (111), (110), and (200) orientations. Morphological analysis unveiled that film surface characteristics were impacted by the number of shots, leading to the formation of smaller Cu 2 O grains as the number of shots increased. The transmittance spectra of Cu 2 O thin films displayed remarkable optical transparency, approximately 80%. The optical bandgap of the films was determined to be 2.57 eV, decreasing to 2.08 eV with an increase in the number of shots, aligning well with values reported for photovoltaic absorber layers. Optoelectronic properties, including optical and electrical conductivities, optical mobility, optical carrier concentrations, refraction loss, optical resistivity, plasmon, and damping frequencies, were computed. The results underscore the significant impact of the number of plasma focus shots and hold great promise for enhancing the performance of Cu 2 O-based solar cells.

chemistry, multidisciplinary,crystallography