Abstract:One of the main components of the worldwide transition to sustainable energy is solar cells, usually referred to as photovoltaics. By converting sunlight into power, they lessen their reliance on fossil fuels and the release of greenhouse gases. Because solar cells are decentralized, distributed energy systems may be developed, which increases the efficiency of the cells. Chalcogenide perovskites have drawn interest due to their potential in solar energy conversion since they provide distinctive optoelectronic characteristics and stability. But high temperatures and lengthy reaction periods make it difficult to synthesise and process them. Therefore, we present the inaugural numerical simulation using SCAPS-1D for emerging inorganic BaZrS 3 /CuO heterojunction solar cells. This study delves into the behaviour of diverse parameters in photovoltaic devices, encompassing efficiency (η) values, short-circuit current density (J sc ), fill factor (FF), and open-circuit voltage (V oc ). Additionally, we thoroughly examine the impact of window and absorber layer thickness, carrier concentration, and bandgap on the fundamental characteristics of solar cells. Our findings showcase the attainment of the highest efficiency (η) values, reaching 27.3% for our modelled devices, accompanied by J sc values of 40.5 mA/cm 2 , V oc value of 0.79 V, and FF value of 85.2. The efficiency (η) values are chiefly influenced by the combined effects of V oc , J sc , and FF values. This optimal efficiency was achieved with CuO thickness, band gap, and carrier concentration set at 5 μm, 1.05 eV, and above 10 19 cm −3 , respectively. In comparison, the optimal parameters for BaZrS 3 include a thickness of 1 μm, a carrier concentration below 10 20 cm −3 , and a band gap less than 1.6 eV. Therefore, in the near future, the present simulation will simultaneously provide up an entirely novel field for the less defective perovskite solar cell.

Numerical Simulation of High Efficiency Environment Friendly CuBi2O4-Based Thin-Film Solar Cell Using SCAPS-1D

Design and simulation of a highly efficient CuBi2O4 thin-film solar cell with hole transport layer

Numerical Investigation of CuSbS2Thin Film Solar Cell using SCAPS-1D: Enhancement of Efficiency on Experimental Films by Defect Studies

Numerical simulation to optimize power conversion efficiency of an FTO/GO/Cs2AgBiBr6/Cu2O solar cell

Exploring 32 % efficiency of eco-friendly kusachiite-based solar cells: A numerical study

Modeling and optimization of numerical studies on CuSbS 2 thin film solar cell with ∼ 15% efficiency

Numerical simulation based performance enhancement approach for an inorganic BaZrS3/CuO heterojunction solar cell

Numerical Simulation of Highly Efficient Cs2TiI6 based Pb Free Perovskites Solar Cell with the Help of Optimized ETL and HTL Using SCAPS-1D Software

Numerical modeling and analysis of FeS2-based solar cell employing CuBi2O4 as back surface field layer

Design and performance exploration of Pb-free low-cost all-inorganic perovskite-inspired CuAgBi2I8 solar cells: Theoretical approach

Numerical modelling of CuBi 2 O 4 thin film solar cells with SCAPS-1D: Bridging the gap ideal and non-ideal conditions

Numerical Simulation of Copper Indium Gallium Diselenide Solar Cell with Ultra-Thin BaSi2 Back Surface Field Layer Using the Non-Toxic In2Se3 Buffer Layer

Numerical simulation and performance optimization of a lead-free inorganic perovskite solar cell using SCAPS-1D

Design and simulation of Cu2SnSe3-based solar cells using various hole transport layer (HTL) for Performance Efficiency above 32%

A Numerical Simulation for Efficiency Enhancement of CZTS Based Thin Film Solar Cell Using SCAPS-1D

Design and numerical simulation of lead-free inorganic perovskites (Cs2BiAgI6) solar cell through computation method

Numerical modeling of CuSbSe2-based dual-heterojunction thin film solar cell with CGS back surface layer

Numerical simulation on an efficient n-CdS/p-ZnSnN2/p+-Cu2SnS3/p++- CuGaSe2 thin film solar cell

Numerical Simulation of Cs2AgBiBr6-based Perovskite Solar Cell with ZnO Nanorod and P3HT as the Charge Transport Layers

Non-toxic Cu 3 BiS 3 thin film solar cells with Al doped TiO 2 as electron-transport layers

Numerical Simulation of the Performance of Sb2Se3 Solar Cell via Optimizing the Optoelectronic Properties Based SCAPS-1D