Numerical simulation based performance enhancement approach for an inorganic BaZrS3/CuO heterojunction solar cell

Ahmed A. El-Naggar,Lotfy A. Lotfy,A. A. Felfela,Walid Ismail,Mahmoud Abdelfatah,Swellam W. Sharshir,Abdelhamid El-Shaer

DOI: https://doi.org/10.1038/s41598-024-57636-4

IF: 4.6

2024-04-01

Scientific Reports

Abstract:One of the main components of the worldwide transition to sustainable energy is solar cells, usually referred to as photovoltaics. By converting sunlight into power, they lessen their reliance on fossil fuels and the release of greenhouse gases. Because solar cells are decentralized, distributed energy systems may be developed, which increases the efficiency of the cells. Chalcogenide perovskites have drawn interest due to their potential in solar energy conversion since they provide distinctive optoelectronic characteristics and stability. But high temperatures and lengthy reaction periods make it difficult to synthesise and process them. Therefore, we present the inaugural numerical simulation using SCAPS-1D for emerging inorganic BaZrS 3 /CuO heterojunction solar cells. This study delves into the behaviour of diverse parameters in photovoltaic devices, encompassing efficiency (η) values, short-circuit current density (J sc ), fill factor (FF), and open-circuit voltage (V oc ). Additionally, we thoroughly examine the impact of window and absorber layer thickness, carrier concentration, and bandgap on the fundamental characteristics of solar cells. Our findings showcase the attainment of the highest efficiency (η) values, reaching 27.3% for our modelled devices, accompanied by J sc values of 40.5 mA/cm 2 , V oc value of 0.79 V, and FF value of 85.2. The efficiency (η) values are chiefly influenced by the combined effects of V oc , J sc , and FF values. This optimal efficiency was achieved with CuO thickness, band gap, and carrier concentration set at 5 μm, 1.05 eV, and above 10 19 cm −3 , respectively. In comparison, the optimal parameters for BaZrS 3 include a thickness of 1 μm, a carrier concentration below 10 20 cm −3 , and a band gap less than 1.6 eV. Therefore, in the near future, the present simulation will simultaneously provide up an entirely novel field for the less defective perovskite solar cell.

multidisciplinary sciences

What problem does this paper attempt to address?

The paper aims to address the following issues:

1. **Improving Solar Cell Efficiency**: By numerically simulating a novel inorganic BaZrS3/CuO heterojunction solar cell, the study explores how to optimize its fundamental characteristics to achieve higher energy conversion efficiency.

2. **Parameter Impact Analysis**: A detailed analysis of the effects of the thickness, carrier concentration, and bandgap of the window layer and absorber layer on the basic performance of the solar cell (such as efficiency η, short-circuit current density Jsc, open-circuit voltage Voc, and fill factor FF).

3. **Optimization Condition Determination**: Through simulation experiments, the optimal working conditions are determined to serve as a reference for producing high-efficiency solar devices in the future.

Specifically, the study found that when the CuO layer thickness is 5 micrometers, the bandgap is 1.05 electron volts, and the carrier concentration exceeds 10^19/cm³, an efficiency value of up to 27.3% can be achieved. Additionally, for the BaZrS3 material, the optimal parameters include a thickness of 1 micrometer, a carrier concentration below 10^20/cm³, and a bandgap of less than 1.6 electron volts. These findings provide a new approach for developing perovskite solar cells with fewer defects.