Abstract:High temperature helium gas will provide a thermal efficiency greater than 40%, even using a conventional steam turbine. In addition, helium gas will not react chemically with blanket materials, and surrounding air and water. Tritium will be easily extracted from the coolant too. Thus, it is one of the most attractive coolants for a fusion power reactor, from the economical, safety and environmental points of view. However, a large volumetric flow rate is required owing to the small heat capacity when the pressure is not extremely high. This requires a larger reactor size, larger circulating power and more penetrations, which may increase radiation streaming. A relatively low heat transfer coefficient makes it difficult to apply to a component subjected to a high heat load, such as a divertor plate. We suggest in this study, a helium-solid suspension flow as coolant, to increase the heat capacity and heat transfer coefficient. A gas pressure of 5 MPa, and inlet and outlet temperatures of 400°C and 700°C were chosen. There are few candidates for the structural material which can be used at temperatures higher than 900°C. We have proposed an intermetallic compound of titanium aluminide (TiAl) as candidate structural material of the blanket. Although the database for TiA1 is incomplete, it has high strength and ductility at the operation temperature. Using TiA1, radioactive waste management will be mitigated, since its activity will decrease rapidly. The elongation at room temperature, which is only a few per cent, will be improved through research and development not only in fusion but also in other industrial fields. In this study, spherical pebbles of lithium oxide and small blocks of beryllium were chosen as the breeder and neutron multiplier. Manganese blocks were installed to enhance energy multiplication. A tritium breeding ratio of 1.38 and energy multiplication ratio of 1.35 were obtained with the blanket. The net plant efficiency exceeds 40%, including the circulating power. The peak surface heat flux on the divertor plate was decreased with gas puffing including an impurity near the striking point. In spite of this, the expected peak heat flux was still several MW m−2 from the result of numerical calculation of the edge plasma. To remove so high a heat load, an impinging helium-solid suspension jet was applied to the high heat flux region of the divertor plate. Molybdenum alloy was used as the structural material in this region to keep the surface temperature and thermal stress lower than the design limits. TiAl was used as the structural material of other regions in the divertor chamber. To prevent excessive sputtering erosion, the electron temperature in the divertor plasma must be kept lower than 20 eV.

Engineering challenges and development of the ITER Blanket System and Divertor

ITER blanket engineering challenges and solutions

Design Evolution and Integration of the ITER In-Vessel Components

Concept Design of Fusion Power Shutdown System for ITER

Engineering design of the ITER blanket and relevant research and development results

Overview of the design and R&D of the ITER blanket system

The ITER blanket system design challenge

Numerical Analyses of Electromagnetic Forces on the ITER Blanket Module Shield Block During Major Disruptions

Physics basis for the first ITER tungsten divertor

First principle-based multi-channel integrated modelling in support of the design of the Divertor Tokamak Test facility

ITER-FEAT vacuum vessel and blanket design features and implications for the R&D programme

ITER first wall/shield blanket

Progress on design and R&D of ITER FW/blanket

Design study of helium-solid suspension cooled blanket and divertor plate for a tokamak power reactor

Engineering Conceptual Design of CFETR Divertor

Impact of nuclear heating distribution on the structural behavior of ITER first wall panel 11

ITER blanket manifold system: Integration, assembly and maintenance

Assembly of ITER blanket module to vacuum vessel experimental investigations

Conceptual Design Of A Blanket Module Integrated With Divertor For Cfetr

ITER blanket manifold final design and validation

Interface design of the blanket system for CFETR