Abstract:It is difficult to simulate both the flow field and the chemical reaction using, respectively, the flow state and kinetics calculations and actually reflect the influence of the gas flow state on the chemical change in a selective catalytic reduction (SCR) system. In this study, the flow field and the chemical reaction were therefore coupled to simulate a full Cu-Zeolite SCR system and the boundary conditions of the simulation were set by a relevant diesel engine bench test which included the exhaust temperature, the mass flow, and the exhaust pressure. Then, the influence of the gas flow state on the NOx conversion efficiency was investigated. Specifically, an orthogonal experimental design was used to study the influence of the injection parameters (position, angle, and speed) on the NH3 distribution by establishing the NH3 uniformity coefficient γ at the SCR catalyst capture surface in the flow field simulation. Then, the velocity capture surface of the SCR catalyst front section was sliced into coupled data transfer interfaces to study the effects of exhaust temperature, ammonia to NOx ratio (ANR), and the NO2/NOx on the NOx conversion efficiency. This was used as guidelines to optimize the SCR system control strategy. The results showed that a 1150 mm injection position, a 45°injection angle, and a 23 m/s injection velocity provided the most uniform NH3 distribution on the SCR catalyst capture surface. For constant injection parameters, the NOx conversion efficiency was the highest when the exhaust temperature was 200°C-400°C, the ANR was 1.1, and NO2/NOx was 0.5.

Experimental Investigation of Mass Transfer in NH3 SCR Over Self-Supporting Cu-ZSM-5 Foam

Numerical Investigation on the Intraphase and Interphase Mass Transfer Limitations for NH3-SCR over Cu-ZSM-5

CFD-based investigation of NO x removal from industrial waste gas by selective catalytic reduction (SCR) and selective non-catalytic reduction (SNCR) process using NH 3

Self-synthesis and performance analysis of a Cu-Fe composite ZSM-5 zeolitic catalyst for NOx reduction and particulate matter removal using NH3 SCR

Combined Experimental and Density Functional Theory Study on the Mechanism of the Selective Catalytic Reduction of NO with NH 3 over Metal-Free Carbon-Based Catalysts

Structure-resolved CFD Simulations to Guide Catalyst Packing of Selective NO Reduction

In situ DRIFTS and temperature-programmed technology study on NH 3 -SCR of NO x over Cu-SSZ-13 and Cu-SAPO-34 catalysts

Experimental Investigation on N2O Formation During the Selective Catalytic Reduction of NOx with NH3 over Cu-SSZ-13

Reaction Pathway Investigation on the Selective Catalytic Reduction of NO with NH3 over Cu/SSZ-13 at Low Temperatures.

Micro-structured Cu-ZSM-5 catalyst on aluminum microfibers for selective catalytic reduction of NO by ammonia

On the performance of Fe-Cu-ZSM-5 catalyst for the selective catalytic reduction of NO with NH3: the influence of preparation method

Development of SSZ-13 Based Sulfur Resistant NH 3 -SCR Catalysts

Research Progress of the Selective Catalytic Reduction with NH3 over ZSM-5 Zeolite Catalysts for NOx Removal

Influence of Catalyst Structural Remodelling on The Performance of NH3 ‐SCR Reactions: A Mini Review

Theory and Practice of Metal Oxide Catalyst Design for the Selective Catalytic Reduction of NOx with NH3

Characterization of Commercial Cu-SSZ-13 and Cu-SAPO-34 Catalysts with Hydrothermal Treatment for NH3-SCR of NOx in Diesel Exhaust

Simulation of the flow field and the chemical reaction coupling of selective catalytic reduction (SCR) system using an orthogonal experiment

Numerical Investigation on Promoting Selective Non-catalytic Reduction with Methane Additive by Computational Fluid Dynamics

An Experimental and Modelling Study of the Reactivity of Adsorbed NH3 in the Low Temperature NH3-SCR Reduction Half-Cycle over a Cu-CHA Catalyst

Hybrid Cu-Fe/ZSM-5 Catalyst Prepared by Liquid Ion-Exchange for NOx Removal by NH3-SCR Process

A Study on Chemisorbed Oxygen and Reaction Process of Fe–CuOx/ZSM-5 Via Ultrasonic Impregnation Method for Low-Temperature NH3-SCR