Abstract:The effect of coating cracking during depth-sensing indentation testing (e.g. nanoindentation testing) on systems comprising thin hard coatings (e.g. TiN) on a less stiff, hard substrate (e.g. steel) has been investigated in order to establish whether, at such small scales, the occurrence of annular through-thickness cracks around indentation sites can be detected from load–displacement plots and whether any accompanying localized debonding of the coating from the substrate can also be identified. Experiments were performed on thin TiN and NbN monolayers, and compositionally modulated TiN/NbN and TiN/ZrN deposited onto hard steel or stainless steel substrates. Above a critical load (Pcrit) in the range 80–500mN, all systems exhibited annular through-thickness cracks around indentation sites. The cracking was found to be accompanied by a discrete change in gradient of the loading portion of the load–displacement curve. Also, analysis of the unloading curves beyond this point showed that elastic recovery was controlled by the elastic modulus of the underlying substrate material alone. The cracking mechanism has been characterized using scanning electron microscopy, coupled with optical profilometry to map the detailed z-displacement of the surface — a procedure critical to understanding whether coating–substrate debonding had occurred. Some cracks were found to show a spiral morphology and the effect of indentation loading rate was investigated to see if appearance of these cracks was loading-rate sensitive. Our results highlight the problems inherent in assessing both the interfacial failure and the interfacial fracture toughness of thin film coated systems at the small contact scales (⩽1μm) associated with crack genesis where it is difficult to confirm the extent of sub-surface cracks by conventional means. We have also demonstrated that both load–displacement and load–displacement squared plots are necessary if a more complete understanding of system behaviour is to be gained. Also, a simple fracture mechanics model for the annular cracking behaviour seen in such systems has been derived and used to estimate a value of Gic (the interfacial work of fracture) as 180Jm−2 for the TiN/ZrN-stainless steel system.

Finite element analysis of the critical ratio of coating thickness to indentation depth for coating property measurements by nanoindentation

On the Factors Affecting the Critical Indenter Penetration for Measurement of Coating Hardness

Finite Element Analysis of the Nanomechanics of Hard Coatings on a Soft Polymer Substrate by a Spherical Indenter

Finite Element Analysis of the Indentation Stress Characteristics of the Thin Film/Substrate Systems by Flat Cylindrical Indenters

Effect of Substrate Performance on the Indentation Response of Coated Systems

Use of Scaling Functions to Determine Mechanical Properties of Thin Coatings from Microindentation Tests

Identification of the Anisotropic Elastic Parameters of NiCrAlY Coating by Combining Nanoindentation and Finite Element Method

Numerical simulation for measuring yield strength of thin metal film by nanoindentation method

Numerical study on the measurement of thin film mechanical properties by means of nanoindentation

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

Hardness measurements of thin films-determining the critical ratio of depth to thickness using FEM

Analysis of Tip Effects in Nanoindentation

On the Effect of Substrate Properties on the Indentation Behaviour of Coated Systems

Micromechanics Analysis of Thin Films by FEM

Modeling Effect of Surface Roughness on Nanoindentation Tests

Critical Penetration Depth for Nano/Micro Indentation Test to Determine Elastic-Plastic Film Properties Deposited on Hard Substrates

The effect of coating cracking on the indentation response of thin hard-coated systems

Investigation of the mechanical properties of thin films by nanoindentation, considering the effects of thickness and different coating–substrate combinations

Nano-Indentation for Characterizing Mechanical Properties of Soft Materials

Quantitative Study of Roughness Effect in Nanoindentation on AISI316L Based on Simulation and Experiment

Influence of Indenter Tip Roundness on Hardness Behavior in Nanoindentation