Abstract:We have attempted to apply the computer-based finite element analysis (FEA) method to accurately measure the mechanical properties (e.g., hardness and elasticity) of a soft material by an indentation test. First, an axisymmetric model has been developed using commercially available FEA code ANSYS. The FEA model consisted of a thin Al-film resting on Si-substrate. A spherical indenter has been used to indent the Al-film, which traveled a predefined depth during the loading and unloading cycles. First, numerical simulations were conducted to get the force vs. displacement plot, which was later used to determine the modulus of elasticity and hardness of Al-film. The effects of substrate modulus and indentation depth were thoroughly investigated to determine the modulus and hardness of Al-film. The effect of friction, considered at the interface of indenter and Al-film, was found to offer minimum impact for relatively small indentation depth. The induced force on the Al-film by the indenter has been found to be higher with increasing indentation depth when friction was considered. However the contact stiffness, represented by the slope of the unloading curve, has been found almost the same with and without considering friction. The variation of substrate modulus has been found to be ineffective to capture the Al-film modulus for relatively small indentation depth. However for higher indentation depth, the substrate modulus has been found to offer profound effect to capture the film modulus. The hardness of the Al-film has also been found to be relatively unaffected with variation of substrate modulus. However, the hardness of the Al-film has been found to be higher with friction for relatively high indentation depth. Results obtained from this preliminary research are important to continue further investigation and to characterize the mechanical properties of other soft-materials, e.g., biofilms to minimize its detrimental effects and utilize its favorable aspects in industrial and biomedical applications.

Finite Element Analysis of the Nanomechanics of Hard Coatings on a Soft Polymer Substrate by a Spherical Indenter

Finite element analysis of the critical ratio of coating thickness to indentation depth for coating property measurements by nanoindentation

Identification of the Anisotropic Elastic Parameters of NiCrAlY Coating by Combining Nanoindentation and Finite Element Method

Modeling the Nanomechanical Responses of Biopolymer Composites During the Nanoindentation

Nano-Indentation for Characterizing Mechanical Properties of Soft Materials

Modelling the Nanomechanical Response of a Micro Particle–matrix System for Nanoindentation Tests

On the Factors Affecting the Critical Indenter Penetration for Measurement of Coating Hardness

Finite Element Simulation of Vickers Micro-Indentation Test of Micro-Nano-Composite Ceramic Tool Materials Based on Microstructure Model

Evaluation of the Elastic-Plastic Properties of TiN Coating by Nanoindentation Technologies Using FEM-reverse Algorithm

Micromechanics Analysis of Thin Films by FEM

Finite Element Modeling of Nanoindentation Response of Elastic Fiber-Matrix Composites

Identifying the Viscoelastic Properties of Soft Matter from the Indentation Response of a Hard Film-Soft Substrate System

Finite Element Modeling of the Indentation and Scratch Response of Epoxy/Silica Nanocomposites.

Indenter Geometrical Effects on Sub-Micro/Nano Indentation and Scratch Behaviors of Polymeric Surfaces

Numerical simulation for measuring yield strength of thin metal film by nanoindentation method

Numerical study on the measurement of thin film mechanical properties by means of nanoindentation

Finite Element Analysis of Nanoindentation Responses in Bi2Se3 Thin Films

Investigation of the mechanical properties of thin films by nanoindentation, considering the effects of thickness and different coating–substrate combinations

Modeling Effect of Surface Roughness on Nanoindentation Tests

Use of Scaling Functions to Determine Mechanical Properties of Thin Coatings from Microindentation Tests

A Finite Element Model of the Elastic Planar and Spherical Contact with Hard and Soft Coatings