Numerical Simulation and Optimization of a Cold Model of a Flat Membrane Bioreactor Air Scouring for Membrane Fouling Control
Jing Wang,Miao Lv,YongHao Huang,Le Huang,XianBin Ying,YingFeng Xu,DongSheng Shen,HuaJun Feng,Xiang Zhang
DOI: https://doi.org/10.1016/j.memsci.2021.119814
IF: 9.5
2021-01-01
Journal of Membrane Science
Abstract:Aeration scouring is currently the most common membrane fouling control technology. The optimization of aeration parameters, such as the aeration aperture, aeration pore spacing, and aerator layout height, can improve the efficiency of aeration and reduce the energy consumption of aeration. However, the simulation results cannot guide engineering practices well due to the limitations in the model precision of computational fluid dynamics. On this basis, the study compared and selected the computational fluid dynamics turbulence model. The DES model was used to study the influence of aeration parameters on membrane fouling control. The study showed that the DES turbulence model had a higher precision and accuracy in predicting the average shear force and the instantaneous shear force distribution on the membrane surface than the k-epsilon turbulence model. The average error of the DES turbulence model simulation of a bubble height was only 1.33%, which was 14.33% lower than the 15.66% of k-epsilon. An aeration pore spacing of 20 mm, a height of 100 mm, and an aeration aperture of 2.0 mm were the best layout parameters. The degree of influence of the aeration aperture, the aeration pore spacing, and the height of the aerator layout on the shear force of the membrane surface decreased sequentially. The influence of each interaction on the average shear force of the membrane surface was negligible. Among these parameters, the main reason for the membrane surface shear force was the change in the flow velocity caused by aeration. By calculating the fitting equation and the critical value of the shear force, the critical value of the liquid velocity on the membrane surface that could remove membrane fouling was 0.232 m/s. Although the numerical simulation and optimization of a flat membrane bioreactor air scouring for membrane fouling control were carried out with pure water, it still plays a significant impact on the actual membrane fouling control. These results could guide the optimization design of aeration parameters for flat membrane bioreactors and provide a reference for the analysis of aeration scour control membrane pollution control research.