Abstract:Fouling control strategies play a crucial role in membrane distillation (MD) process, primarily due to the significant limitation of fouling during the scaling-up process. The utilization of microbubbles (MBs) aeration has exhibited promising potential in mitigating membrane fouling when treating high salinity wastewater. Aeration can introduce gas-liquid two-phase flow on the membrane surface, thereby increasing the membrane surface shear force. The mechanism of aeration technology for controlling fouling includes the following points: introduction of gas-liquid two-phase flow; physical substitution of concentration polarization layer; pressure pulses caused by bubbles flowing through the membrane surface and increasement of the cross flow velocity. This research aims to optimizing the effect of air MBs with different concentrations and sizes introduced in the feed side on membrane fouling control, we creatively used the method of releasing pressure gradiently to achieve size regulation of MBs within a certain range for the first time, firstly regulated the generation of MBs by manipulating gas flow rate and release pressure. Under the optimal condition of 40 mL/min and 0.6 MPa, it will yield concentration of 1.58 × 10 4 /mL and D50 Sauter size of 64.69 μm MBs with pure water permeance flux of 12.32 kg/(m 2 ·h). It was observed that higher gas flow rates primarily increased MBs concentration, while lower pressures predominantly reduced MBs size through the method of inline imaging. Experimental results indicated that introduction of MBs can slightly improve the temperature polarization coefficient and mass transfer coefficient under different operating modes. Consequently, further investigations focused on the influence of MBs characteristics on different fouling control. All conditions reach 99 % rejection for inorganic salt and HA. This study provided empirical evidence that higher concentration and larger size of MBs intensify the gas-liquid two-phase flow disruption and exhibit a better shear effect on scaling phenomena, which yield advantageous outcomes in terms of augmenting permeance flux and water vapor production, with permeance flux increased from 40.12 % to 55.42 % for inorganic fouling and increased from 68.35 % to 80.15 % for inorganic and HA fouling. These results were confirmed via membrane surface using scanning electron microscopy and energy dispersive spectroscopy. In summary, this research aided in identifying appropriate operating conditions for mitigating inorganic and composite scaling by implementing air-infused MBs in direct contact membrane distillation (DCMD), which provides scientific and technical guidance for controlling fouling in MD in practical applications.

Assessment of combination of pressure-relief pulsation flow and diatomite filter-aid in membrane fouling control

Fabrication of High-Flux PTFE Hollow Fiber Membranes Through Nonionic Surfactant Infiltration Coupled with Mussel-Inspired Chemistry Coating

Improved Ultrafiltration Performance Through Dielectric Barrier Discharge/sulfite Pretreatment: Effects of Water Matrices and Mechanistic Insights

Enhanced Mitigation of Membrane Fouling and Degradation of Perfluorooctanoic Acid in the Treatment of Natural Surface Water Through the Application of Dielectric Barrier Discharge/sulfite

A review of CFD simulation in pressure driven membrane with fouling model and anti-fouling strategy

Optimizing fouling mitigation in membrane distillation by controlled microbubble size and concentration

New Insights into Membrane Fouling During Direct Membrane Filtration of Municipal Wastewater and Fouling Control with Mechanical Strategies.

Synergy of Slippery Surface and Pulse Flow: an Anti-Scaling Solution for Direct Contact Membrane Distillation

Dynamic pore modulation of contracted carbon fiber filter for wastewater treatment: Filtration performance and in-situ regeneration mechanism

Diatomite Precoat Filtration for Wastewater Treatment: Filtration Performance and Pollution Mechanisms

Pressure-induced piezoelectric response for mitigating membrane fouling in surface water treatment: Insights from continuous operation and biofouling characterization

A combined model for describing the trans-membrane pressure (P) variation in constant flux dead-end microfiltration (MF) process

Diatomite Enhanced Dynamic Membrane Technology for Simultaneous Backwash Sludge Pre-Dewatering and Backwash Wastewater Recycling

Hydrophilic Fe2O3 Dynamic Membrane Mitigating Fouling of Support Ceramic Membrane in Ultrafiltration of Oil/water Emulsion

Enhanced Coagulation/Flocculation by Combining Diatomite with Synthetic Polymers for Oily Wastewater Treatment

Enhanced anti-fouling of forward osmosis membrane by pulsatile flow operation in textile wastewater treatment

Effective suppression of concentration polarization by nanofiltration membrane surface pattern manipulation: Numerical modeling based on LIF visualization

Development of high flux dynamic membrane based on hydrodynamic and mass transfer for enhanced antifouling property and dye removal

Mitigating membrane fouling by coupling coagulation and the electrokinetic effect in a novel electrocoagulation membrane cathode reactor

Coupling Ferrate Pretreatment and In-Situ Ozonation/ceramic Membrane Filtration for Wastewater Reclamation: Water Quality and Membrane Fouling

Principles and Performance of A Submerged Internal-Circulation Membrane Coagulation Reactor