Abstract:Relaxation and/or backwashing have been incorporated in most membrane bioreactor (MBR) designs as standard operating strategies to limit fouling. However, to maintain a certain net permeate production, higher instantaneous fluxes have to be applied to compensate for the loss of permeate caused by those modes of operation. To assess the effects of the different operational parameters on fouling for the same water productivity, and to study the fouling mechanisms, three relaxation and five backwashing conditions were applied in a lab-scale aerobic MBR and compared to the continuous filtration mode. Moreover, the fouling behaviour was analyzed in terms of the consequential increase in trans-membrane pressure, resistance fractions and the biopolymeric composition of the fouling layer. The Pearson correlation analysis was applied to identify the major contributor to fouling. From this study, it was found that fouling could be retarded effectively when the appropriate filtration mode was applied. The instantaneous flux applied to compensate for the loss of productivity during backwashing or relaxation periods was the major factor affecting fouling rate for either relaxation or backwashing, which was significantly correlated with the amount of solids and soluble fractions deposited on the membrane surface. The relaxation and backwashing conditions (i.e. duration, interval, strength) also considerably affected the fouling rate. In addition, it was found that pore blocking was more likely to be due to protein rather than carbohydrates and that the cake layer was the major contributor to fouling.

A new mathematical model to describe the trans-membrane pressure in the coupled cleaning process (rinsing + backwash)

A Combined Mechanism (the Open Pores-Cake Dissolution) Model for Describing the Trans-Membrane Pressure (p(t)) Reduction in the Backwash Process at a Constant Flow Rate

A Chemically Enhanced Backwash Model for Predicting the Instantaneous Transmembrane Pressure of Flat Sheet Membranes in Constant Flow Rate Mode

A new model considering the morphological changes of cake and gel for the in-situ membrane cleaning process

A combined model for describing the trans-membrane pressure (P) variation in constant flux dead-end microfiltration (MF) process

A New Model Based on the Cake Removal and the Re-Deposition Mechanism in the Rinsing Process

A Model Describing the Pressure Drops Across the Membrane and Cake Layers for Constant Flux Cross-Flow Microfiltration Process

A New Composite Model of the Membrane Cleaning for Predicting the Fouling Resistance in the Hydraulic Cleaning Process

A Kinetic Model for Calculating Total Membrane Fouling Resistance in Chemical Cleaning Process

Dual-objective for the Mechanism of Membrane Fouling in the Early Stage of Filtration and Determination of Cleaning Frequency: A Novel Combined Model

Membrane Cleaning in Membrane Bioreactors: A Review

Influence of operating conditions on cleaning efficiency in sequencing batch reactor (SBR) activated sludge process — water rinsing introduced membrane filtration process

Study on the Membrane Fouling of the Process of Using Two Layer Flat-Sheet Membrane for Sludge Thickening and Water Reuse

Relationship Between Sludge Characteristics and Membrane Flux Determination in Submerged Membrane Bioreactors

Optimization of coupling filtration and rinsing processes by Pontryagin maximum principle

A Multi-Functional Rinsing Model Based on Cake Properties for Predicting Rinsing Efficiency and Calculating Energy Consumption in MBR

Fouling and Cleaning of Microfiltration Membrane in Municipal Wastewater Reclamation.

New and practical mathematical model of membrane fouling in an aerobic submerged membrane bioreactor.

Optimization of surface water microfiltration with hydraulic and chemically enhanced backwashing

Effects of Relaxation and Backwashing Conditions on Fouling in Membrane Bioreactor

Modeling Of Membrane Fouling Based On Extracellular Polymers In Submerged Mbr