Abstract:Direct membrane filtration (DMF) has gained a lot of attention in recent years because of its potential to treat low-strength and low temperature wastewater, where biological based treatments are inefficient. However, fouling is a major concern which keeps this technique from being more widely used. The main aim of this study was to investigate membrane fouling, its mitigation approaches and the organic/nutrient retention during DMF of municipal wastewater by adjusting operational parameters and pretreating the sewage. In a laboratory-scale setup employing crossflow to mitigate fouling, both ultrafiltration and microfiltration membranes were utilized. Physicochemical pre-treatment of sewage with polyaluminum chloride and polyamide significantly inhibited membrane fouling and improved organics/nutrient retention. Subsequent experiments with physiochemically pre-treated sewage, using microfiltration and ultrafiltration separately, revealed that (i) an increase in crossflow velocity from 1 to 2 m s −1 improved filtration performance by reducing irreversible fouling, (ii) elevating transmembrane pressure from 0.18 to 0.4 bar increased both reversible and irreversible fouling, and (iii) periodic relaxation increased the extent of irreversible fouling, contributing to higher overall fouling in ultrafiltration. When employing DMF for sewage concentration, ultrafiltration demonstrated superior filtration performance and organics retention compared to microfiltration. Furthermore, through pre-precipitation and microsieving (100 μm) followed by DMF with ultrafiltration membranes, a remarkable removal efficiency of 92 % for chemical oxygen demand (COD), 98 % for total phosphorus (TP), and 100 % for total suspended solids (TSS) was achieved. By cleaning the fouled membranes using an alkaline cleaning solution (Ultrasil-10) at 50 °C, combined with a crossflow of 1 m s −1 , the permeability was completely restored. Overall, this study demonstrates that by optimizing operational settings and cleaning conditions, a sustainable DMF process for wastewater treatment with controlled membrane fouling and improved resource recovery can potentially be developed for upscaling. Short abstract This study investigated the effectiveness of direct membrane filtration for municipal wastewater treatment. It was found that physicochemical pre-treatment with polyaluminum chloride and polyamide significantly reduced membrane fouling and improved nutrient retention. Ultrafiltration membranes demonstrated superior performance and nutrient retention compared to microfiltration membranes. By optimizing operational parameters and cleaning conditions, a sustainable direct membrane filtration process with controlled fouling and improved resource recovery can be developed for wastewater treatment.

Optimization of surface water microfiltration with hydraulic and chemically enhanced backwashing

Direct Membrane Filtration (DMF) of municipal wastewater – A study on the prevention and remediation of fouling

Fouling and Mitigation Mechanisms During Direct Microfiltration and Ultrafiltration of Primary Wastewater

Fouling and Cleaning of Microfiltration Membrane in Municipal Wastewater Reclamation.

A transient biological fouling model for constant flux microfiltration

Direct Membrane Filtration of Municipal Wastewater: Linking Periodical Physical Cleaning with Fouling Mechanisms

Improved low-carbon-consuming fouling control in long-term membrane-based sewage pre-concentration: The role of enhanced coagulation process and air backflushing in sustainable sewage treatment

A modeling and experimental comparative study of a closed-loop forward osmosis-nanofiltration and standalone nanofiltration systems for fouling-prone wastewater treatment

Fouling Control in Ceramic Nanofiltration Membrane: Forward Flush and Precoating Method

Investigating effective strategies for sustainable operation of a submerged anaerobic membrane bioreactor (SAnMBR) coupled with ceramic ultrafiltration membrane

A new mathematical model to describe the trans-membrane pressure in the coupled cleaning process (rinsing + backwash)

A surface-renewal model for constant flux cross-flow microfiltration

Fouling and Chemical Cleaning Strategies for Submerged Ultrafiltration Membrane: Synchronized Bench-Scale, Full-Scale, and Engineering Tests

Continuation of a cleaning process: Application of MNBs-coagulation process to mitigate ultrafiltration membrane fouling

Protein-folding-inspired approach for UF fouling mitigation using elevated membrane cleaning temperature and residual hydrophobic-modified flocculant after flocculation-sedimentation pre-treatment

Pre-concentration of Municipal Wastewater Using Flocculation-Assisted Direct Ceramic Microfiltration Process: Optimization of Operational Conditions

Mitigation of reverse osmosis membrane fouling by electrochemical-microfiltration- activated carbon pretreatment

Critical Flux and Chemical Cleaning-In-Place During the Long-Term Operation of A Pilot-Scale Submerged Membrane Bioreactor for Municipal Wastewater Treatment

Ultrasonication-assisted Fouling Control During Ceramic Membrane Filtration of Primary Wastewater under Gravity-Driven and Constant Flux Conditions

Optimization of coupling filtration and rinsing processes by Pontryagin maximum principle

A combined model for describing the trans-membrane pressure (P) variation in constant flux dead-end microfiltration (MF) process