Abstract:In this study, ozone catalysts (hydrogenation-modified red mud, HM-RM) successfully prepared by hydrogenation-modification of industrial hazardous solid waste red mud (RM) as a raw material in accordance with the viewpoint of treating waste with waste and using waste. Meanwhile, as for the common phenomenon of membrane fouling, uneven distribution of multiphase solid catalysts and ozone in liquids, the addition of ultrasound can not only disperse materials, but also play a role in online cleaning of ceramic membranes and catalysts. The optimum treatment conditions for Rhodamine B (RhB) solution with volume of 2 L and concentration of 40 mg/L were catalyst concentration of 0.4 mg/L, reaction temperature of 45 °C, ultrasonic time of 1 h, ultrasonic intensity of 600 W, removal rate of RhB was up to 90 %. In addition, the computational fluid dynamics (CFD) simulation method was used to investigate the fluid flow between the two gas-liquid phases and the effect of the negative pressure of the membrane pump on the fluid by the analysis of flow, pressure and ozone flux of the ceramic membrane(CM) reaction apparatus. The CFD simulation results showed that at the inlet gas-liquid flow rate of 3 m/s and the negative pressure of 20,000 Pa, the maximum flow rates of CM-1 were 3 m/s, 0.752 m/s for CM-2, and 0.228 m/s for CM-3, respectively. Vortices, which are beneficial to solid-liquid mixing and gas-liquid mass transfer, formed between the suction port CM-1 of CM-1 and the inlets of CM-2 and CM-3. This discovery is consistent with relevant experimental research results. Significantly higher concentrations of both •OH and dissolved ozone were observed in the US/HM-RM/O3 system compared to other systems, indicating the significant improvement in ozone utilization rate through the application of ultrasound. The superiority of the US/HM-RM/O3 device was demonstrated. The real dye effluent was tested under optimum operating conditions and the results showed that COD and TOC were reduced by 81.34 % and 60.23 % respectively after 180 min of treatment. The above research can provide technical support for the treatment of dye wastewater using Ultrasound-enhanced ozone oxidation ceramic membranes.

Residence time and the concentration of microorganism in the ozone contactor: a CFD simulation on chamber deflectors

Numerical Verification for a New Type of UV Disinfection Reactor

Unraveling Dissolved Organic Matter in Drinking Water Through Integrated Ozonation/ceramic Membrane and Biological Activated Carbon Process Using FT-ICR MS.

Evaluating hydraulic and disinfection efficiencies of a full-scale ozone contactor using a RANS-based modeling framework

Control of Biofilm Growth in Drinking Water Distribution System by Biodegradable Carbon and Disinfectant Residuals

Using a membrane contactor for ozone mass transfer study and model dye wastewater treatment

Enhanced Mass Transfer of Ozone and Emerging Pollutants through a Gas-Solid-Liquid Reaction Interface for Efficient Water Decontamination

Evaluating Effective Volume and Hydrodynamic Behavior in a Full-Scale Ozone Contactor with Computational Fluid Dynamics Simulation

Enhanced Mitigation of Membrane Fouling and Degradation of Perfluorooctanoic Acid in the Treatment of Natural Surface Water Through the Application of Dielectric Barrier Discharge/sulfite

Insights into the mechanism of electrostatic field promoting ozone mass transfer in water: A molecular dynamics perspective

Investigating the suitability of online flow cytometry for monitoring full-scale drinking water ozone system disinfection effectiveness

Construction of a flow-through catalytic reactor employing O 3 -Fe/TiO 2 for efficient catalytic ozonation disinfection

Coupling changes of disinfectant and bacteria induced by the water stagnation and disinfection strategy

Numerical Simulation and Optimization of a Cold Model of a Flat Membrane Bioreactor Air Scouring for Membrane Fouling Control

CFD and Experimental Model Studies for Water Disinfection Tanks with Low Reynolds Number Flows

CFD Simulation and Optimization of the Water Treatment Reactor by Electron Beam

Numerical investigation on mixing behaviour in the contact zone of an industrial‐scale dissolved air flotation tank

Modeling and Optimization of Synergistic Ozone-Ultraviolet-chlorine Process for Reclaimed Water Disinfection: from Laboratory Tests to Software Simulation.

Continuous ultrasonic ozone coupling technology-assisted control of ceramic membrane fouling coupled enhanced multiphase mixing to treat dye wastewater and CFD flow field simulation

Optimizing Metal‐Surface Water Disinfection: CFD Study on Microorganism Collision Against a Triply Periodic Minimal Surface (Adv. Sustainable Syst. 7/2024)

Application of a Hybrid Gravity-Driven Membrane Filtration and Dissolved Ozone Flotation (MDOF) Process for Wastewater Reclamation and Membrane Fouling Mitigation