Abstract:The moving bed biofilm reactor (MBBR) has certain advantages, such as high wastewater treatment efficiency, low maintenance and operating costs, and simple operation. It has emerged as a valuable option for small decentralized facilities. The filling ratio, aeration mode and aeration intensity are the main factors that affect the performance of MBBRs in wastewater treatment. However, the information that concerns the used criteria that pertain to the process design for the MBBR is not adequate. In this study, a three dimensional computational fluid dynamics (CFD) model was constructed and the maximum error was only 1.98%, which was much smaller than the traditional 2D-CFD model. The filling ratio, aeration mode and aeration intensity of MBBR were optimized by CFD model from the point of view of fluid mechanics. The results show that the fluidization performance of the filling is the best under the one-side aeration mode with 30% filling ratio. The cost-performance ratio of the reactor with 30% filling ratio was 1.53, 25% and 35% filling ratio were only 1.17 and 1.14 respectively. Increasing the aeration intensity could improve the fluidization performance. However, the effect of high aeration intensity on the fluidization performance of the carrier was limited and the energy consumption increased greatly. The results revealed that when the aeration intensity increased from 0.07 min-1 to 0.13 min-1, the proportion of the carrier area increased by 16.56%. The proportion of the carrier area with an aeration rate of 0.20 min-1 was only 4.23%, which is higher than 0.13 min-1. The main factors that control the fluidization of the carrier were the range of the flow zone and the flow velocity of the liquid. Increasing the range of the flow zone could facilitate the flow of the carriers. The critical value of the flow velocity of the liquid in the flow zone was 0.04 m/s. These results could guide the optimization design of the filling ratio and the aeration conditions and provide a theoretical basis for the application of MBBR.

CFD Simulation and Optimization of the Water Treatment Reactor by Electron Beam

A review on the water treatment reactor by electron beam

The Hydrodynamics of Low-Density Particles and Optimization of the EMMS Calculation Process

CFD simulation of cross flow in multi-tubular fixed-bed reactor of industrial level

Review on Hydrodynamic Behavior of Continuous Flow Reactors for Water Treatment by Electron Beam

Numerical Verification for a New Type of UV Disinfection Reactor

Numerical Investigation of Hydrodynamics and Heat Transfer for Bingham-pseudoplastic Fluids in an Industrial Coiled Stirred Tank

Optimization of the Internal Circulating Fluidized Bed Using Computational Fluid Dynamics Technology

Experimental Research on the Gas-Solid Flow Characteristics in Large-Scale Dual Fluidized Bed Reactor

Design and structural parameter optimization of Venturi-type microbubble reactor for wastewater treatment by CFD simulation

CFD simulation for comparative of hydrodynamic effects in biochemical reactors using population balance model with varied inlet gas distribution profiles

Computational fluid dynamic for improving design and performance of an external loop airlift reactor used in electrochemical wastewater treatment

CFD and Experimental Model Studies for Water Disinfection Tanks with Low Reynolds Number Flows

CFD simulation of hydrodynamics in downer reactors

Residence time and the concentration of microorganism in the ozone contactor: a CFD simulation on chamber deflectors

CFD as a Tool to Optimize Aeration Tank Design and Operation

Electron Beam Radiation Coupled to Flocculation for Advanced Treatment of Coking and Dyeing Wastewater: Performance and Synergistic Effect

NumericaI simuIation of the design of disinfection treatment unit

Hydraulic Characteristics, Residence Time Distribution, and Flow Field of Electrochemical Descaling Reactor Using CFD

Numerical Simulation of Hydrodynamic Behaviors of Internal Circulation Bio-Fluidized Bed Reactor

Numerical study of hydrodynamic characteristics in a moving bed biofilm reactor