Abstract:The existence of two "transition" boiling curves has been discovered for over three decades, and has recently been re-examined in the investigations of quenching on superhydrophilic surfaces with enhanced boiling heat transfer, where the stable film boiling regime usually disappears and a significantly extended transitional film boiling sub-regime emerges instead, leading to a two-section shape of the transition boiling curve. It was hypothesized that the critical point at the slope change on the transition boiling curve is related to the transition in intensity frequency of the solid-liquid contact status. Although it sounds rational, this hypothesis has not yet been proved due to the lack of a quantitative characterization on the solid-liquid contact. In this work, the electrochemical impedance technique was employed to perform in situ measurements on the interfacial solid-liquid contact during quenching on a superhydrophilic surface (over a stainless steel ball) in a very dilute aqueous electrolyte. It was found that the solid-liquid contact proportion in the transitional film boiling sub-regime is around 0.1, which becomes much greater in the transitional nucleate boiling sub-regime. This corresponds to a sharp increase on the contact proportion curve, which was found to occur in accordance with the transition in the boiling curve. The measured proportions thus provide an intuitive evidence to verify, for the first time in the literature, the hypothesized transition of solid-liquid contact mode from "point-contact" to "surface-contact" in the transition boiling regime. This method can be used to give more insights into the mechanisms for enhanced boiling heat transfer on superhydrophilic surfaces with novel micro-inanostructures. (C) 2019 Elsevier Ltd. All rights reserved.

Transitioning water to an enhanced heat-conducting phase

Transient Performance of a Thermal Energy Storage-Based Heat Sink Using a Liquid Metal As the Phase Change Material

Mechanisms for Enhanced Transition Boiling During Quenching on a Superhydrophilic Surface As Revealed by in Situ Characterization on the Solid-Liquid Contact Using Electrochemical Impedance Technique

Experimental Investigation of Transpiration Cooling With Phase Change in High Temperature Flow

Study of the Natural Circulation Flow Boiling Heat Transfer Based On Partially Superhydrophilic Surface Modification

Enhancement and maximum in the isobaric specific-heat capacity measurements of deeply supercooled water using ultrafast calorimetry

Anomalous Enhancement of Heat Transfer to H2O/CO2 Mixtures in Near-Critical Region

Heat Transfer in Porous Media Heated From Above With Evaporation, Condensation, and Capillary Effects

Transition to a Superpermeation Phase of Confined Water Induced by a Terahertz Electromagnetic Wave.

Unified theoretical framework for temperature regulation via phase transition

Heat flowing from cold to hot without external intervention by using a 'thermal inductor'

Experiments on the Transient Heat Transfer of Minichannel Heat Sink under High Heat Flux Density in an Enclosed Loop

Heat Transfer Performance Potential with a High-Temperature Phase Change Dispersion

Numerical investigation on the characteristics of coolant flow, heat absorption and phase change in transpiration cooling process

Heat Transfer Characteristics of Supercritical Water in Inclined Upward Tube

Thermo-fluidic Characteristics of Contact Melting Mechanism for Water-Phase Change Material Mixture: A Numerical Optimization

Molecular Dynamics Study of Phase Transition Heat Transfer in Water Nanofilm on Nanorough Surfaces

Liquid-liquid transition in supercooled aqueous solution involving a low-temperature phase similar to low-density amorphous water

Radiative Heat Transfer to Enhance the Performance of Liquid Metal-Based Phase Change Heat Sink under Natural Convection Condition

Experimental investigation of thermal performance in a shell-and-tube phase change thermal energy storage unit with an inner square tube

Enhanced Transitional Heat Flux by Wicking During Transition Boiling on Microporous Hydrophilic and Superhydrophilic Surfaces