Abstract:Multi-gigahertz fundamental repetition rate, tunable repetition rate and wavelength, ultrafast fiber lasers at wavelengths of 1.0, 1.5, and 2.0 µm are experimentally demonstrated and summarized. At the wavelength of 1.0 µm, the laser wavelength is tuned in the range of 1040.1-1042.9 nm and the repetition rate is shifted by 226 kHz in a 3-cm-long all-fiber laser by controlling the temperature of the resonator. Compared with a previous work where the maximum average power was 0.8 mW, the power in this study is significantly improved to 57 mW under a launched pump power of 213 mW, thus achieving an optical-to-optical efficiency of 27%. For comparison, a similar temperature-tuning technique is implemented in a Tm3+-doped ultrafast oscillator but, as expected, it results in a broader tunable range of 14.1 nm (1974.1-1988.2 nm) in wavelength as compared with the value of 1.8 nm for the wavelength of 1.0 µm. The repetition rate in the process is shifted by 294 kHz. For the high-frequency range from 100 kHz to 10 MHz, the value of integrated timing jitter gradually increases with an increase in temperature. Finally, to the best of our knowledge, for the first time, a new method for tuning wavelength and repetition rate is proposed and demonstrated for a femtosecond fiber laser at the wavelength of 1.5 µm. Through fine rotation of the alignment angle between the Er/Yb:glass fiber and a semiconductor saturable absorption mirror, the peak wavelength can be tuned in the range of 1591.4-1586.1 nm and the repetition rate is shifted by 60 kHz.

Low repetition rate 915 nm figure-9 ultrafast laser with all-fiber structure

Optical Microfiber-Based Ultrafast Fiber Lasers

Ultrafast Raman fiber laser: a review and prospect

Flexible high-repetition-rate ultrafast fiber laser

High-repetition-rate Ultrafast Fiber Lasers.

Research Advances in Ultrafast Raman Fiber Lasers

Femtosecond Mode-locked Fiber Laser at 1 Μm Via Optical Microfiber Dispersion Management

Compact, repetition rate locked all-PM fiber femtosecond laser system based on low noise figure-9 Er:fiber laser

Generation of sub-30 fs pulses from an erbium-doped fiber amplifier at 203 MHz repetition rate

GHz-rate 57-fs acousto-optic mode-locking fiber laser based on cascaded all-fiber pulse compression

All-fiber Mode-Locked Gigahertz Femtosecond Laser at 1610 Nm Using a Self-Developed Long-Wavelength Gain Fiber

High-repetition-rate All-Fiber Femtosecond Laser with an Optical Integrated Component.

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.

High energy (> 40 nJ), sub-100 fs, 950 nm laser for two-photon microscopy

Widely Tunable Ultrafast Sources For Multi-Photon Microscopy

All-Fiber High Repetition Rate Short Pulse Generation Around 1030Nm

All fiber ultrafast laser generating gigahertz pulse based on a hybrid plasmonic microfiber resonator

Ultra-Compact Q-Switched Single-Frequency Pulsed Fiber Lasers

Compact, All-PM Fiber Integrated and Alignment-Free Ultrafast Yb:Fiber NALM Laser With Sub-Femtosecond Timing Jitter

Compact all-fiber ring femtosecond laser with high fundamental repetition rate.

All-fiber Ultrafast Laser Generating Gigahertz-Rate Pulses Based on a Hybrid Plasmonic Microfiber Resonator