Solid–Liquid Two-Phase Flowmeter Flow-Passage Wall Erosion Evolution Characteristics and Calibration of Measurement Accuracy

Wei Han,Lumin Yan,Rennian Li,Jing Zhang,Xiang Yang,Lei Ji,Yan Qiang

DOI: https://doi.org/10.3390/pr12051012

IF: 3.5

2024-05-17

Processes

Abstract:Solid–liquid two-phase flowmeters are widely used in critical sectors, such as petrochemicals, energy, manufacturing, the environment, and various other fields. They are indispensable devices for measuring flow. Currently, research has primarily focused on gas–liquid two-phase flow within the flowmeter, giving limited attention to the impact of solid phases. In practical applications, crude oil frequently contains solid particles and other impurities, leading to equipment deformation and a subsequent reduction in measuring accuracy. This paper investigates how particle dynamic parameters affect the erosion evolution characteristics of flowmeters operating in solid–liquid two-phase conditions, employing the dynamic boundary erosion prediction method. The results indicate that the erosion range and peak erosion position on the overcurrent wall of the solid–liquid two-phase flowmeter vary with different particle dynamic parameters. Erosion mainly occurs at the contraction section of the solid–liquid two-phase flowmeter. When the particle inflow velocity increases, the erosion range shows no significant change, but the peak erosion position shifts to the right, primarily due to the evolution of the erosion process. With an increase in particle diameter, the erosion range expands along the inlet direction due to turbulent diffusion, as particles with lower kinetic energy exhibit better followability. There is no significant change in the erosion range and peak erosion position with an increase in particle volume fraction and particle sphericity. With a particle inflow velocity of 8.4 m/s, the maximum erosion depth reaches 750 μm. In contrast, at a particle sphericity of 0.58, the minimum erosion depth is 251 μm. Furthermore, a particle volume fraction of 0.5 results in a maximum flow coefficient increase of 1.99 × 10−3.

engineering, chemical

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the wall erosion characteristics of the flow - measurement channel in the solid - liquid two - phase flow meter due to the influence of solid particles and its impact on the measurement accuracy. Specifically, the research focuses on how different particle dynamic parameters (such as particle inflow velocity, particle volume fraction, particle diameter, etc.) affect the wall erosion characteristics and measurement accuracy of the solid - liquid two - phase flow meter. Through the dynamic boundary erosion prediction method, the research aims to provide a theoretical reference to improve the measurement accuracy of the solid - liquid two - phase flow meter in practical engineering applications, prevent the equipment from deforming due to erosion, and thus ensure the accuracy and reliability of the measurement.