A physically-based structure-property model for additively manufactured Ti-6Al-4V

Xinyu Yang,Richard A. Barrett,Noel M. Harrison,Sean B. Leen

DOI: https://doi.org/10.1016/j.matdes.2021.109709

2021-07-01

Abstract:<p>A physically-based, mixed-phase structure-property model is presented for microstructure-sensitivity of tensile stress-strain response, including yield stress, ultimate tensile strength, uniform elongation and flow stress (strain hardening), for additively manufactured Ti-6Al-4V. The interdependent effects of solutes, grain size, phase volume fraction and dislocation density are explicitly included. Solid-state phase transformation and dislocation density evolution are incorporated to simulate the effects of martensite dissolution and <span class="math"><math>α</math></span>-<span class="math"><math>β</math></span> transformation at high temperature. Predictions are validated by comparison with measured tensile test data for (i) effects of additive manufacturing process conditions (such as build orientation and sample size) on tensile properties, based on the microstructure attributes inherited from the process, and (ii) the effect of temperature on tensile stress-strain response across a broad range of temperatures. The model is thus applicable for rapid process-structure-property prediction, in conjunction with AM process modelling, to capture the effects of key manufacturing variables and for process optimization.</p>

materials science, multidisciplinary

What problem does this paper attempt to address?

This paper mainly discusses the application of a physics-based, multiphase structure-property model in additive manufacturing (AM) Ti-6Al-4V alloy. The model considers the interactions between solute, grain size, phase volume fraction, and dislocation density to simulate the tensile stress-strain response, including yield stress, ultimate tensile strength, uniform elongation, and flow stress (strain hardening). In the paper, the authors validate the model's predictions of tensile properties with experimental data and investigate the influence of temperature on the tensile stress-strain response in different ranges.

The paper points out that traditional Ti-6Al-4V has a dual-phase structure consisting of α and β phases, while AM Ti-6Al-4V, due to its complex heating-cooling cycle and high cooling rate, forms a martensitic transformation with insufficient diffusion, with a microstructure typically composed of 5% β grains and 95% needle-like α' grains. The model considers solid-state phase transformations and dislocation density evolution to simulate the processes of martensite dissolution and α-β transformation at high temperatures.

The research objective is to develop a rapid down-selection method to effectively study the mechanical behavior of AM materials. By combining AM process modeling, the model can predict the influence of key manufacturing variables for process optimization. The paper compares the limitations of existing data-driven artificial intelligence models and microscale models and proposes a physics-based model to reduce the number of fitting parameters and improve prediction reliability.

In conclusion, the paper addresses how to predict the structure-property relationship of AM Ti-6Al-4V alloy through a physics model to optimize the manufacturing process and understand the influence of different process conditions on material performance.