Abstract:Self-mixing interferometry (SMI) is suitable to sense and measure vibrations of amplitudes ranging from picometers to millimeters at frequencies from sub-Hz to MHz’s. As an optical probe, SMI has the advantage of being non-invasive with the ability to measure without any treatment of the target surface and operate from a substantial standoff distance from the target. As an additional advantage, the SMI configuration is much simpler than that of conventional interferometers as it does not require any optical part external to the laser source. After a short introduction to the basics of SMI, we review the development of configurations of SMI instruments for vibration measurements, based on both analog and digital processing, with record performance to cover the range of vibration amplitudes from 0.1 nm to 1 mm, frequencies up to MHz, and stand-off distances up to 100 m. These performances set a benchmark that is unequaled by other approaches reported so far in the literature. The configurations we describe are (i) a simple MEMS-response testing instrument based on fringe counting, (ii) a half-fringe locking vibrometer for mechanical mode analysis and transfer function measurements, with a wide linear response on six decades of amplitude, (iii) a vibrometer with analog switching cancellation for μm-to-mm amplitude of vibrations, and (iv) a long standoff distance vibrometer for testing large structures at distances up to 100 m and with nm sensitivity. Lastly, as the vibrometer will almost invariably operate on untreated, diffusing surfaces, we provide an evaluation of phase-induced speckle pattern errors affecting the SMI measurement.

Improving the measurement performance for a self-mixing interferometry-based distance and velocity sensing system using VMD

A Three-dimension High-Precision and Non-contact Dynamic Angular Displacement Measurement System based on Heterodyne Interference

Self-tuning Variational Mode Decomposition

Sinusoidal Phase-Modulated Angle Interferometer for Angular Vibration Measurement.

Self-Mixing Interferometry Cooperating with Frequency Division Multiplexing for Multiple-Dimensional Displacement Measurement

Displacement Sensing for Laser Self-Mixing Interferometry by Amplitude Modulation and Integral Reconstruction

Vibration Measurements by Self-Mixing Interferometry: An Overview of Configurations and Benchmark Performances

Micro-vibration measuring technology based on heterodyne interference

Laser self-mixing interferometry for dynamic displacement sensing of multiple targets

Improving the precision of weak-value-amplification with two cascaded Michelson interferometers based on Vernier-effect

Noncontact Distance and Amplitude-Independent Vibration Measurement Based on an Extended DACM Algorithm

A hybrid system for simultaneous velocity and distance measurements in dynamic experiments

Influence of Stimulated Brillouin Scattering on Positioning Accuracy of Long-Range Dual Mach-Zehnder Interferometric Vibration Sensors

Range-Velocity Measurement Accuracy Improvement Based on Joint Spatiotemporal Characteristics of Multi-Input Multi-Output Radar

Analysis and Compensation of Synchronous Measurement Error for Multi-Channel Laser Interferometer

A modulated positioning scheme for asymmetric vibration sensor using high-frequency carrier

Real-Time Algorithm for Versatile Displacement Sensors Based on Self-Mixing Interferometry

The Influence of Fiber Inhomogeneity on the Positioning Accuracy of Distributed Fiber Vibration Sensor

Self-mixing Interferometry Based on Nanometer Fringes and Polarization Flipping

Symmetrical Dual In-line Sagnac Fiber Sensor Based on VMD-GCC for High Precision Localization

Sinusoidal phase-modulating self-mixing interferometer with nanometer resolution and improved measurement velocity range