Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

The Impact of Gate Annealing on Leakage Current and Radio Frequency Efficiency in AlGaN/GaN High-Electron-Mobility Transistors

Improved Electrical Performance of InAlN/GaN High Electron Mobility Transistors with Forming Gas Annealing

Effect of gate structures on the DC and RF performance of AlGaN/GaN HEMTs

Influence of Post Fabrication Annealing on Device Performance of Inaln/Gan High Electron Mobility Transistors

Effect of annealing on the electrical performance of N-polarity GaN Schottky barrier diodes

Thermal Analysis of AlGaN/GaN High-Electron-Mobility Transistor and Its RF Power Efficiency Optimization with Source-Bridged Field-Plate Structure

NiO/AlGaN interface reconstruction and transport manipulation of p-NiO gated AlGaN/GaN HEMTs

Effect of High Temperature on the Performance of AlGaN/GaN T-Gate High-Electron Mobility Transistors With ~140-nm Gate Length

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer

Effects of Polycrystalline AlN Film on the Dynamic Performance of AlGaN/GaN High Electron Mobility Transistors

Annealing Process on MOS channel Properties for Quasi‐Vertical GaN‐on‐Sapphire Trench MOSFET

Protection of Isolated and Active Regions in AlGaN/GaN HEMTs Using Selective Laser Annealing*

Improving Performance of Al2O3/AlN/GaN MOSC-HEMTs Via Microwave Annealing

Improvement Performance of p-GaN Gate High-Electron-Mobility Transistors with GaN/AlN/AlGaN Barrier Structure

Performance Analysis of AlN/GaN HEMTs on β-Ga2O3 Through Exploration of Varied Back Barriers: An Investigative Study for Advanced RF Power Applications

Study of Self-Heating and High-Power Microwave Effects for Enhancement-Mode p-Gate GaN HEMT

Electrical and Thermal Characteristics of AlGaN/GaN HEMT Devices with Dual Metal Gate Structure: A Theoretical Investigation

Effect of Device Geometry on Static and Dynamic Performance of AlGaN/GaN-on-Si High Electron Mobility Transistor

Analysis and Reduction of the Gate Forward Leakage Current in AlGaN/GaN HEMTs Employing Energy-Band Modulation Technology

Effect of InGaN Channel on Radio‐Frequency Performance in High‐Electron‐Mobility Transistors with an InAlGaN Barrier

Improved Device Performance in AlGaN/GaN HEMT by Forming Ohmic Contact with Laser Annealing