Abstract:In this study, a continuum damage mechanics (CDM) finite element (FE) model was developed to investigate the effects of surface roughness on rolling contact fatigue (RCF) life of non-conformal contacts. In order to assess the surface roughness of tribo-components, twelve deep groove rolling element bearings from various companies in different sizes were procured and measured using an optical surface profilometer. The roughness average (Ra) and the root mean square of surface roughness (RMS, σ) ranged from a low of 0.03, 0.05 µm to a high of 0.14, 0.20 µm, respectively. The number of peaks and valleys per 400 µm were measured and calculated. The number of peaks ranged from 11 to 31 (>99.5% Confidence Interval). The measured surfaces also revealed that a sinusoidal pattern can be used to accurately represent the surface patterns. The sinusoidal surface pattern was used to determine the elastohydrodynamic lubrication (EHL) pressure distribution between an equivalent rough surface in contact with a smooth surface. Four roughness amplitude were used to generate specific film thicknesses (λ-ratios) resulting in full to mixed EHL lubrication regimes. The EHL pressure distributions were replaced with representative symmetric Hertzian pressure distributions in order to remove the effect of asymmetry of an EHL pressure distribution. The resulting symmetric pressure distributions were used in a finite element continuum damage mechanics model to determine RCF life of machine elements operating in specific film thickness range of 1 < λ < 10. The RCF results from the FE model indicate that as roughness amplitude increases or lambda ratio decreases, the fatigue lives decrease for the various frequencies. Additionally, subsurface failure fatigue lives are reduced as roughness frequency increases regardless of amplitude or Hertzian pressure. The RCF results also indicate that for the low frequency pressure distribution the contact is most susceptible to surface failure, whereas for high frequency pressure distribution the contact resists surface failure. The results from this investigation were used to develop surface roughness effects for various RCF life equations commonly used in rolling element bearing application.

Study on predicting rolling contact fatigue of pitch bearing raceway in offshore wind turbine

Investigation on 3D fatigue crack propagation in pitch bearing raceway of offshore wind turbines

Fatigue Analysis of Jacket Foundations for Offshore Wind Turbines

Fatigue Life Analysis of Monopile-Supported Offshore Wind Turbines Based on Hyperplastic Ratcheting Model

Research on Rolling Contact Fatigue Failure of the Bearing Used in High-Speed Electric Multiple Units’ Axle Box Based on a Damage-Coupled Elastic–Plastic Constitutive Model

3D Multiscale Dynamic Analysis of Offshore Wind Turbine Blade under Fully Coupled Loads

Fatigue life analysis of slewing bearings in wind turbines

A modified nonlinear fatigue damage accumulation model for life prediction of rolling bearing under variable loading conditions

The effect of friction on surface crack initiation in rolling contact fatigue considering damage accumulation

A continuum damage mechanics finite element model for investigating effects of surface roughness on rolling contact fatigue

A crystal plasticity framework for modelling the rolling contact fatigue of planetary roller screw mechanism

Comparison of Rolling Contact Fatigue Life Between Elastohydrodynamic Lubricated Point Contacts Pre and Post Running-in Treatment

A peridynamic study on the effects of surface topography on rolling contact fatigue

Study on Condition Monitoring of Pitch Bearings Based on Stress Measurement

A Fast and Practical Method for Predicting the Fatigue Life of Offshore Wind Turbine Jacket Support Structures

Load Distribution Research on Pitch Bearing of Wind Turbine Generators

Fatigue Reliability Analysis of Wind Turbine Drivetrain Considering Strength Degradation and Load Sharing Using Survival Signature and FTA

Fatigue Life Analysis of Main Shaft Bearings in Wind Turbines Using Strain Measurements Collected on Blades

Contact force and pressure analysis of the three-row roller pitch bearing in a large-scale wind turbine

Fatigue reliability analysis and assessment of offshore wind turbine blade adhesive bonding under the coupling effects of multiple environmental stresses