Abstract:Rotating machinery requires adequate sealing to reducing the secondary leakage between high-pressure and low-pressure regions and in turn improve efficiency. Different types of annular gas seals are used for multiple turbomachinery applications. This includes finger, leaf, brush (for more specialized applications), hole and honeycomb patterned seals. In comparison to other configurations, labyrinth seals are most commonly used due to their high robustness and low manufacturing costs in rotating machinery applications. The recently introduced T-type labyrinth seal has the potential to reduce the fluid-induced excitations in the aero-engines in comparison to conventional ones. Seal clearance from the rotor surface plays an important role in the performance and efficiency of the seal in terms of rotor dynamics and leakage rate. Therefore, a parametric analysis is required to determine the optimal clearance which not only reduces the leakage but also minimizes the overall contribution to the vibration of the system. It is known that the T-type seals have T shape teeth which provide a greater increase in the inward radial aerodynamic force. This inward force is due to the enhanced Lomakin effect of the seal flow field. The earlier research has shown that the leakage of T-type labyrinth seal is approximately 23.6% to 25.3% less than the straight through (i.e., conventional) labyrinth seals by keeping the same tip clearance and axial length for the seal. This paper focuses on the sensitivity analysis using the design of experiments (DOE) along with the steady-state computational fluid dynamics (CFD) to determine the optimum tip clearance for the reduced leakage rate of a T-type labyrinth seal. Since the fluid-induced excitations play a significant role in the rotordynamic system, equivalent rotordynamic coefficients are extracted using steady-state CFD simulation based on the circular whirl orbit and perturbation analysis, where the small perturbation is applied to the rotor, which is generally 10% of the seal clearance. In this study, conventional labyrinth seal is numerically modelled, and then verified through test results existing in the literature. In addition, the numerical results are compared with existing simulation results in literature. The effective damping of conventional and T-type labyrinth seals is also calculated using the equivalent rotordynamic coefficients. The previous research on the T-type seals is used for benchmarking and validation of the analysis.

Analysis of a ring-type seal by the finite element method

Performance Analysis of the Cylinder Gas Film Seal between Dual-Rotor Reverse Shafts Considering Lubrication and Centrifugal Expansion Effects

Investigation on sealing gap between ring gear and case in internal gear machines

Analysis of High Pressure Liquid Seal Ring Distortion and Stability Using Finite Element Methods

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

Computational Analysis of Sealing and Stability of a Deformable Floating and Fixed Rings of an Annular Seal

Numerical and experimental evaluation of performance of centrifugal seals

Dynamic Analysis of Spiral-Groove Rotary Seal Ring for Wet Clutches

Analysis of Leakage Flow and Dynamic Characteristics in Floating Ring Seals for High Pressure Turbopump

Failure Analysis and Improvement of Mechanical Seals in Underwater Turbine

Performance Analysis of the Shallow Slot Split Floating Ring Seal

Coupling Analysis of Frictional Heat of Fluid Film and Thermal Deformation of Mechanical Seal End Faces

Dynamic Characteristic Analysis of the Shallow Slot-Split Floating Ring Seal

A Bulk-Flow Analysis of Static and Dynamic Characteristics of Floating Ring Seals

Determination of the Equivalent Rotordynamic Coefficients and Leakage of a T-Type Labyrinth Seal

Use of hydrated material for dynamic seal faces in shaft seal

Leakage performance of floating ring seal in cold/hot state for aero-engine

Nonlinear Dynamic Analysis of a Rotor/bearing/seal System

Analysis on Modeling Rotor System with Sidling Bearing and Ring Seal by Using FEM

Fluid-structure interaction analysis of annular seals and rotor systems in multi-stage pumps

Influence Analysis of Secondary O-Ring Seals in Dynamic Behavior of Spiral Groove Gas Face Seals