Abstract:Coupler rubber buffers are widely used in high-speed trains, to dissipate the impact energy between vehicles. The rubber buffer consists of two groups of rubbers, which are pre-compressed and then installed into the frame body. This paper specifically focuses on the energy absorption characteristics of the rubber buffers. Firstly, quasi-static compression tests were carried out for one and three pairs of rubber sheets, and the relationship between the energy absorption responses, i.e. E ab n = n × E ab 1 , E diss n = n × E diss 1 , and E a n = E a 1 , was obtained. Next, a series of quasi-static tests were performed for one pair of rubber sheet to investigate the energy absorption performance with different compression ratios of the rubber buffers. Then, impact tests with five impact velocities were conducted, and the coupler knuckle was destroyed when the impact velocity was 10.807 km/h. The results of the impact tests showed that with the increase of the impact velocity, the E ab , E diss , and E a of the rear buffer increased significantly, but the three responses of the front buffer did not increase much. Finally, the results of the impact tests and quasi-static tests were contrastively analyzed, which showed that with the increase of the stroke, the values of E ab , E diss , and E a increased. However, the increasing rates of the impact tests were higher than that of the quasi-static tests. The maximum value of E a was 68.76% in the impact tests, which was relatively a high value for the vehicle coupler buffer. The energy capacity of the rear buffer for dynamic loading was determined as 22.98 kJ.

Enhancing Train Coupling Simulation by Incorporating Speed-Dependent Energy Absorber Characteristics Through a Deep Neural Network

Simulation Method for Couplers and Buffers in Train Collision Calculations

Physics-informed deep neural networks for simulating S-shaped steel dampers

Effect of an inter-vehicle damper on the dynamics of a high-speed train

Convergence Enhancement for Neural Network Integrated Power System Time Domain Simulation

Dynamic performances of an innovative coupler used in heavy haul trains

Dynamic Damage Detection and Assessment on the Bogie Frame of High-Speed Train Based on the Coupled Elastic and Multibody Dynamics Scheme

Multistage Impact Energy Distribution for Whole Vehicles in High-Speed Train Collisions: Modeling and Solution Methodology

Design and Analysis of the Hybrid Excitation Rail Eddy Brake System of High-Speed Trains

Simplified Dynamic FEA Simulation for Post-Derailment Train-Behaviour Estimation through the Enhanced Input of Wheel–Ballast Friction Interactions

Data-driven simulation for general-purpose multibody dynamics using Deep Neural Networks

Dynamic Characteristics of a Traction Drive System in High-Speed Train Based on Electromechanical Coupling Modeling under Variable Conditions

Hybrid structural analysis integrating physical model and continuous‐time state‐space neural network model

Performance Simulation of Shock Absorbers Based on Neural Network

A hybrid damping control strategy for high-speed trains running on existing tracks

Deformation Analysis and Prediction of a High-Speed Railway Suspension Bridge under Multi-Load Coupling

Probabilistic safety analysis of coupled train-bridge system using deep learning based surrogate model

Optimisation of an inter-vehicle damper for a high-speed train

Dynamic decoupling and compensation based on the inverted network technique and experiment research for multi-axis hydraulic road simulator

Experimental investigation of the quasi-static and impact tests on the energy absorption characteristics of coupler rubber buffers used in railway vehicles