Abstract:Track structures are apt to generate degradation under repeated loading of train traffic. Avariation of support stiffness is one of the main degradations, such as unsupported sleepers and the transition position from embankment to a bridge, which occurred frequently. The service performance of track will decline including the comfort index of passengers and the safety of train in these areas. In order to understand the control standard of track stiffness variation, various models have been used to analyze the amplification of dynamic responses of track by researchers. The coupling effect of train and track structure was considered unnegligible in some researches. In this paper, an updated numerical model is developed based on track dynamic theory, in which the CA mortar and concrete base are both taken into consideration. The results were compared with the finite element model ( FEM) results based on ABAQUS software, in which the train loads are assumed as a series of constant loads. From the comparison, the influence of train-track interaction was presented. When the track has no irregularity or degradation, the wheel-rail contact loads are nearly constant, and the dynamic responses of track structure are the same in these two models. But if there are track stiffness variations,the results in train-track interaction model are larger than that in FEM,which means that the train-track interaction has an intensive effect. Besides the differences of track responses, the FEM cannot reveal the variation of contact forces and train responses, which are also essential to summarize the control standard of track degradation. At last, based on the train-track interaction model, various conditions of track stiffness variation are analyzed and discussed.

Simplified Dynamic FEA Simulation for Post-Derailment Train-Behaviour Estimation through the Enhanced Input of Wheel–Ballast Friction Interactions

Three-dimensional Finite Element Simulation on Moving Load Induced Track Response over Stiffness-varied Base

Dynamic Analysis of Rockfall Impact on Bridges: Implications for Train Safety

Investigation on train dynamic derailment in railway turnouts caused by track failure

An investigation into post-derailment self-protection mechanisms for railway vehicles

Simulation for running attitude of a train after derailment

Numerical investigation on the dynamic behaviour of derailed railway vehicles protected by guard rail

Simulation of the Running Attitude of a Train after Derailment

Study on train running safety in railway switches and sharp curves considering wheel wear evolution

Numerical investigation of dynamic derailment behavior of railway vehicle when passing through a turnout

Design and Analysis of Train Anti-Derailment Device Based on Full-Scale Derailment Tests

A New Semi-Active Safety Control Strategy for High-Speed Railway Vehicles

Assessment of safety against derailment using simulations and vehicle acceptance tests: a worldwide comparison of state-of-the-art assessment methods

Numerical simulation of the post-derailment behaviour of a railway vehicle and its interaction with the infrastructure

Dynamic simulation analysis of rail track and track structure based on SIMPACK and ABAQUS

Dynamic Response Analysis of Ballasted Railway Track–Ground System under Train Moving Loads using 3D Finite Element Numerical Modelling

Evaluation of dynamic derailment in a railway switch considering the longitudinal impacts caused by vehicle retarder

Comparative Study on Dynamic Responses of Ballasted and Ballastless Tracks at Critical Velocity

Dynamic Simulation of Tank Car Derailment and Structure Optimization Based on Solidworks, ADAMS, and ANSYS

Dynamic damage evolution of double-block ballastless track structure under train derailment impact

Dynamic wheel/rail interactions for high-speed trains on a ballasted track