Combustion of Silane-Nitrous Oxide-Argon Mixtures: Analysis of Laminar Flame Propagation and Condensed Products
R. Mevel,K. P. Chatelain,Y. He,S. Lapointe,D. A. Lacoste,M. Allix,N. Chaumeix,C. -E. Paillard
DOI: https://doi.org/10.1016/j.proci.2020.06.381
IF: 6.535
2021-01-01
Proceedings of the Combustion Institute
Abstract:The laminar burning rate, the explosion peak pressure, and the pressure rise coefficient have been measured for the first time for silane-nitrous oxide-argon mixtures using the spherically expanding flame technique in a constant volume combustion chamber. For these three parameters, the values obtained were higher than for hydrogen-nitrous oxide-argon and typical hydrocarbon-based mixtures. A maximum burning rate of 1800 g/m(2) s was measured at 101 kPa, whereas under similar conditions, a maximum burning rate around 950 g/m(2) s has been reported for hydrogen-nitrous oxide-argon mixtures. To better understand the chemical dynamics of flames propagating in SiH4-N2O-Ar mixtures, a detailed reaction model from the literature was improved using collision limit violation analysis and updated thermodynamic properties calculated with a high-level ab initio approach. The reaction model predicts the burning rate within 14% on average but demonstrates error close to 50% for the richest mixtures. The chemistry of the H-O-N system is important under all the conditions presently studied. The chemistry of the Si-H-O-N system demonstrates an increasing importance under rich conditions. In particular, the reactions (i) forming SiOx (s); (ii) describing the interaction of Si-species with N2O; and (iii) involving silicon hydrides, have an important role for the heat release dynamics. The condensed combustion products formed in the silane-nitrous oxide-argon flames were sampled and characterized using electron micrograph, electronic diffraction, energy-dispersive spectroscopy, and X-ray powder diffraction. For all equivalence ratios, silica spherical particles with a mean diameter in the range 200-300 nm were observed. In addition, for mixtures with phi >= 2.2, silicon nanowires were formed. X-ray diffraction experiments showed that the silicon nanowires are composed of metal silicon characterized by a cubic structure (lattice parameter: a = 5.425 angstrom) with the Fm-3m space group. (c) 2020 The Combustion Institute. Published by Elsevier Inc. All rights reserved.