Abstract:The growing need for sustainable and low-carbon energy sources has led to significant research in alternative fuels. The majority of energy produced today comes from fossil fuels, which has led to enormous emissions of greenhouse gases. The direct combustion of fossil fuels produces syngas and hydrogen, which contribute to global warming. In contrast, the gasification process of biomass produces clean energy in the form of syngas and hydrogen. The biomass and plastic co-gasification has gained a lot of attention recently due to the challenges associated with gasifying biomass and plastic wastes separately. The broader objectives of this study are to alleviate these waste management problems and optimize the syngas LHV and H 2 content using co-gasification process. The synthesis gas is a crucial intermediary used to create chemicals and fuels for transportation. The hydrogen component of synthesis gas can also be utilized directly as fuel for hydrogen fuel cells, which produce electricity. This work employs Aspen simulator to analyze an optimum processing condition where the synthesis gas has the maximum feasible hydrogen content and calorific value which has not been investigated in the available literature so far. Aspen software is used in this study since it can be useful in figuring out reaction yield and performing parametric studies to optimize process conditions. It is found that the carbon dioxide emission sharply decreases as the proportion of plastic increases in co-gasification. The mole fractions of CO, H 2 and CO 2 that the current model predicts using experimental data on rice husk have average modeling errors of less than 8%, indicating a satisfactory fit with the experimental findings. Under 1 bar of pressure and a combined feed rate of 100 kg/h for both plastic and biomass, the simulation was run at temperatures between 550 °C and 1300 °C. When steam was added, the fraction of hydrogen increased by approximately a factor of two for a steam-to-biomass ratio (SBR) of 2. Following the addition of plastic to the feed, the amount of hydrogen in the produced gas rose for all temperatures. When 15% plastic is combined with the feed at 850 °C, carbon dioxide is reduced by roughly 60%. The results indicate significant increase in calorific value of the product as well as the hydrogen proportion—suggesting plastic addition as an excellent method to improve the LHV of biomass gasification.

Process variable optimization on hydrogen production from sawdust mill of Paraserianthes falcataria wood with one stage gasification process using promoted calcium hydroxide absorption

Process Optimization and CO2 Emission Analysis of Coal/Biomass Gasification Integrated with a Chemical Looping Process

An Experimental And Response-Surface-Based Optimization Approach Towards Production Of Producer Gas In A Circulating Fluidized Bed Gasifier Using Blends Of Renewable Fibre-Based Biomass Mixtures

Hydrogen production via integrated configuration of steam gasification process of biomass and water‐gas shift reaction: Process simulation and optimization

Hybrid-functional Material for Sorption-Enhanced Hydrogen-Rich Syngas Production from Biomass: Effect of Material Preparation Process

Hydrogen Rich Fuel Gas Production by Gasification of Wet Biomass Using A Co2 Sorbent

Cow Dung Gasification Process for Hydrogen Production Using Water Vapor as Gasification Agent

Syngas-Enriched hydrogen production via catalytic gasification of water hyacinth using renewable palm kernel shell hydrochar

Enhancement of Depolymerization Slag Gasification in Supercritical Water and Its Gasification Performance in Fluidized Bed Reactor

Advancing hydrogen generation: Kinetic insights and process refinement for sorption-enhanced steam gasification of biomass utilizing waste carbide slag

Preparation of Hydrogen via Catalytic Gasification of Residues from Biomass Hydrolysis with a Novel High Strength Catalyst

Hydrogen Production Via Cao Sorption Enhanced Anaerobic Gasification of Sawdust in A Bubbling Fluidized Bed

Process Integration of Hydrogen Production Using Steam Gasification and Water‐Gas Shift Reactions: A Case of Response Surface Method and Machine Learning Techniques

A novel sludge pyrolysis and biomass gasification integrated method to enhance hydrogen-rich gas generation

Catalytic Gasification of Algal Biomass for Hydrogen-Rich Gas Production: Parametric Optimization Via Central Composite Design

A Modified Two-Stage Sorption-Enhanced Steam Gasification of Biomass Process for H2 Production

Thermodynamic Analysis of A Biomass Anaerobic Gasification Process for Hydrogen Production with Sufficient Cao

Potential of Hydrogen Production from Biomass

Optimization of hydrogen and syngas production from PKS gasification by using coal bottom ash

Hydrogen Production by Supercritical Water Gasification of Biomass: Explore the Way to Maximum Hydrogen Yield and High Carbon Gasification Efficiency

Syngas and hydrogen production from co-gasification of rice husk biomass and plastic waste mixture using Aspen Plus