Abstract:Highly efficient hydrogen production from biomass can be realized by using catalysts in the reaction process under more mild hydrothermal conditions. Among various catalysts, Ni based catalysts are considered as the most promising catalyst for hydrogen production due to its low cost and good catalytic activity. In order to solve the problem of catalyst deactivation caused by carbon deposion at the acid site of Ni/Al2O3,the additives were studied to modify the Ni based catalysts loaded on Al2O3 in our research group. Cu, Co, Ce and Mg were chosed as additive and bimetal Ni-M or complex oxide catalysts were prepared by co-impregnation, impregnation by step, and co-precipitation, etc. The results show that the introduction of metal Ce can effectively improve the catalytic activity of hydrogen production, and the resistance of carbon deposition can also be improved, indicating that metal Ce is a suitable additive. Mg additive can restrain the formation of crystalline carbon on the surface of Ni-Al catalyst. Much lower heat-treating temperature or impregnation by step in preparation can obtain more effective active sites for Ni-Mg-Al catalyst. Moreover, Mg additive can improve the catalytic activity and hydrothermal stability of Ni-Al catalyst. As to the Ni catalyst loaded on rutile TiO2 prepared by sol-gel process, Ni crystals with much higher dispersity can be achieved by lowering the heat-treating temperature, which provide more active sites and promote the C-C bond breaking of biomass under hydrothermal conditions as well as water gas shift reaction and methanation reaction, thus improving the conversion efficiency of biomass. The thermodynamic analysis was performed with Aspen Plus V7.3.2. The thermodynamic models was built using the P-R equation of state and the MHV2 mixing rule to predict the gas yields in the hydrothermal gasification process. Hydrothermal gasification of biomass and its model compounds was theoretically analyzed. The equilibrium state of hydrothermal gasification reaction was obtained by calculating the gas production under certain temperature and pressure, which points out the direction and limitation of hydrothermal gasification reaction.

Catalytic Gasification of Algal Biomass for Hydrogen-Rich Gas Production: Parametric Optimization Via Central Composite Design

Improving carbon-reduced catalytic gasification of microalgae for biohydrogen production

Co-hydrotreating of Algae and Used Engine Oil for the Direct Production of Gasoline and Diesel Fuels or Blending Components

Gasification of Algal Residue for Synthesis Gas Production

Catalytic Hydrothermal Gasification Of Microalgae For Producing Hydrogen And Methane-Rich Gas

Hydrogen production via integrated configuration of steam gasification process of biomass and water‐gas shift reaction: Process simulation and optimization

Parametric studies on hydrothermal gasification of biomass pellets using Box-Behnken experimental design to produce fuel gas and hydrochar

Parametric Characterization of Air Gasification of Chlorella Vulgaris Biomass

Hydrogen Production by Hydrothermal Gasification of Biomass：Catalysts and Thermodynamic Analysis

Optimization of biohydrogen production from microalgae by response surface methodology (RSM)

Supercritical water gasification of microalgal biomass for hydrogen production-A review

Catalytic Supercritical Water Gasification of Aqueous Phase Directly Derived from Microalgae Hydrothermal Liquefaction

Maximizing Liquid Fuel Production from Reformed Biogas by Kinetic Studies and Optimization of Fischer–Tropsch Reactions

Oxidative torrefaction of microalgae Chlorella sorokiniana : Process optimization by central composite design

Preparation of Hydrogen via Catalytic Gasification of Residues from Biomass Hydrolysis with a Novel High Strength Catalyst

Catalytic treatment of crude algal bio-oil in supercritical water: optimization studies

Hydrogen-rich Energy Recovery from Microalgae (Lipid-Extracted) Via Steam Catalytic Gasification

Supercritical Water Gasification of Microalgae over a Two-Component Catalyst Mixture

Process variable optimization on hydrogen production from sawdust mill of Paraserianthes falcataria wood with one stage gasification process using promoted calcium hydroxide absorption

Ex Situ Catalytic Pyrolysis of Algal Biomass in a Double Microfixed-Bed Reactor: Catalyst Deactivation and Its Coking Behavior

Application of Fe Based Composite Catalyst in Biomass Steam Gasification to Produce Hydrogen Rich Gas