Abstract:The growing need for sustainable and low-carbon energy sources has led to significant research in alternative fuels. The majority of energy produced today comes from fossil fuels, which has led to enormous emissions of greenhouse gases. The direct combustion of fossil fuels produces syngas and hydrogen, which contribute to global warming. In contrast, the gasification process of biomass produces clean energy in the form of syngas and hydrogen. The biomass and plastic co-gasification has gained a lot of attention recently due to the challenges associated with gasifying biomass and plastic wastes separately. The broader objectives of this study are to alleviate these waste management problems and optimize the syngas LHV and H 2 content using co-gasification process. The synthesis gas is a crucial intermediary used to create chemicals and fuels for transportation. The hydrogen component of synthesis gas can also be utilized directly as fuel for hydrogen fuel cells, which produce electricity. This work employs Aspen simulator to analyze an optimum processing condition where the synthesis gas has the maximum feasible hydrogen content and calorific value which has not been investigated in the available literature so far. Aspen software is used in this study since it can be useful in figuring out reaction yield and performing parametric studies to optimize process conditions. It is found that the carbon dioxide emission sharply decreases as the proportion of plastic increases in co-gasification. The mole fractions of CO, H 2 and CO 2 that the current model predicts using experimental data on rice husk have average modeling errors of less than 8%, indicating a satisfactory fit with the experimental findings. Under 1 bar of pressure and a combined feed rate of 100 kg/h for both plastic and biomass, the simulation was run at temperatures between 550 °C and 1300 °C. When steam was added, the fraction of hydrogen increased by approximately a factor of two for a steam-to-biomass ratio (SBR) of 2. Following the addition of plastic to the feed, the amount of hydrogen in the produced gas rose for all temperatures. When 15% plastic is combined with the feed at 850 °C, carbon dioxide is reduced by roughly 60%. The results indicate significant increase in calorific value of the product as well as the hydrogen proportion—suggesting plastic addition as an excellent method to improve the LHV of biomass gasification.

Supercritical water Co-gasification of biomass and plastic wastes for hydrogen-rich gas production using Ni-Cu/AC-CaO catalyst

A novel sludge pyrolysis and biomass gasification integrated method to enhance hydrogen-rich gas generation

Hydrogen-rich syngas production via catalytic gasification of sewage sludge and wheat straw using corn stalk char-supported catalysts

Conversion of kitchen waste effluent to H2-rich syngas via supercritical water gasification: Parameters, process optimization and Ni/Cu steam reforming reaction. Moreover

Comprehensive experimental study on supercritical water gasification of oilfield sludge: Effect of operation parameters, and catalysts on the products

Production of H2-rich Syngas from Gasification of Unsorted Food Waste in Supercritical Water

Assessment of Sewage Sludge Gasification in Supercritical Water for H-2-rich Syngas Production

Biomass steam gasification for hydrogen-rich syngas production over fly ash-based catalyst pretreated by coupling of washing and calcination

Conversion of kitchen waste effluent to H<sub>2</sub>-rich syngas via supercritical water gasification: Parameters, process optimization and Ni/Cu catalyst

Assessment of Supercritical Water Gasification of Food Waste under the Background of Waste Sorting: Influences of Plastic Waste Contents

Syngas and hydrogen production from co-gasification of rice husk biomass and plastic waste mixture using Aspen Plus

Hydrogen‐Rich Syngas Production by DC Thermal Plasma Steam Gasification from Biomass and Plastic Mixtures

Hydrogen production via integrated configuration of steam gasification process of biomass and water‐gas shift reaction: Process simulation and optimization

Evaluation of Catalytic Subcritical Water Gasification of Food Waste for Hydrogen Production: Effect of Process Conditions and Different Types of Catalyst Loading

Hydrogen Production by Catalytic Supercritical Water Gasification of Black Liquor-Based Wastewater

Co-pyrolysis–catalytic steam reforming of cellulose/lignin with polyethylene/polystyrene for the production of hydrogen

Enhancement of hydrogen production in steam gasification of sludge: Comparing different strategies for deeper conversion of hydrogen sources in biomass

Coupling biomass gasification and inline co-steam reforming: Synergistic effect on promotion of hydrogen production and tar removal

Hydrogen Production by Three-Stage (i) Pyrolysis, (ii) Catalytic Steam Reforming, and (iii) Water Gas Shift Processing of Waste Plastic

Product Characterization of Hydrothermal Liquefaction and Supercritical Water Gasification of Water Hyacinth

Study on mechanism of supercritical water gasification of hemicellulose for hydrogen-rich syngas based on experiments and reaction molecular dynamics simulations