Abstract:In this letter, a hybrid multiorder wide bandpass frequency selective surface (FSS) with high selectivity and low insertion loss is achieved by combining the two-dimensional (2-D) FSS structure and the 3-D vertical structure. The 3-D periodic vertical printed circuit board pieces (PVPCB) are used as the dielectric layer in the unit cell to achieve a proper band flatness without introducing great insertion loss. The multiorder response of the proposed FSS is achieved using a series of 3-D PVPCB instead of stacking the 2-D FSS layers. The proposed FSS unit cell is constructed by combining the full-wave and equivalent circuit simulations, since the physical structures have a good one-to-one correspondence with the circuit elements. The module design method is used to accelerate the design procedure, and the simulation result proves the effectiveness of this design method. Finally, the prototype is fabricated and measured to prove the effectiveness of the proposed FSS. The measured relative bandwidth and rectangle coefficient achieved is 130.4 and 0.76, respectively. The measured maximum insertion loss over the whole passband is 0.7 dB. Because of its strong capability of out-of-band rejection, the proposed FSS structure is a good candidate to enhance high-frequency electromagnetic pulse protection of wideband radar systems.

Bandpass Frequency Selective Surfaces with Fast Roll-off Characteristics

A Bandpass Frequency Selective Surface With a Low Cross-Polarization Based on Cavities With a Hybrid Boundary

Bandpass Frequency Selective Surface with Two Sharp Sidebands Based on Shunted Quarter‐mode Substrate Integrated Waveguide Cavities

Filtenna-Filtenna Design for Broadband and High-Selectivity Frequency Selective Surface

22/43 GHz low-insertion-loss dual-polarized multi-layer bandpass frequency selective surfaces for millimeter astronomy

A Novel Angularly Stable Wide Passband Frequency Selective Surface

A Compact Second-Order Frequency Selective Surface With Broadband Response

High Roll-Off Frequency Selective Surface With Quasi-Elliptic Bandpass Response

Design and Synthesis of Band-Pass Frequency Selective Surface With Wideband Rejection and Fast Roll-Off Characteristics for Radome Applications

A Novel Fss Based on Hybrid Boundary Condition Cavity

The Design Of A Broad Band Third-Order Frequency-Selective Surfaces

A Modified High-Selective Frequency Selective Surface Designed by Multilevel Green's Function Interpolation Method

A Tri-Band, Highly Selective, Bandpass FSS Using Cascaded Multilayer Loop Arrays

A Novel Frequency Selective Surface with Smaller Size and Wide Band

A Quad-Band Highly Selective Frequency Selective Surface with Ultra-Wideband Rejection

Design of Broadband Band-pass Frequency Selective Surfaces

Fabrication of Dual-Passband Frequency Selective Surface Utilizing Complementary Structure

X-band Frequency Selective Surface with Low Loss and Angular Stability

Dual-Band High Selective Frequency Selective Surface Design and Analysis

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

A Hybrid 2-D–3-D Miniaturized Multiorder Wide Bandpass FSS