Abstract:The present study aimed at investigating the microstructure evolution mechanism and mechanical properties of the rare earth magnesium alloy (Mg-RE alloy). The compression tests over a temperature range of 250-450 °C as well as the interrupted compression tests at a temperature of 350 °C and a strain rate of 0.1 s−1 to strains of 0.02, 0.39, 0.79 and 1.48 were conducted by using Gleeble-3800. The results show that there exists a critical transition temperature of material performance. When the temperature is lower than 350 °C, the fracture occurs at the strain of 0.31 and there was poor toughness; on the contrary, when the temperature is higher than 350 °C, there is no crack even if the strain is up to 1.49. At the same time, the material exhibited pseudo-super plastic behavior. Furtherly, the microstructure tends to be uniform and fine grains exist around some large and long grains. And, many particles emerge in the grains and at the grain boundaries. These results imply that dynamic recrystallization occurs in advance during deformation. It is found that the second-phase particles play an important role in particle stimulated nucleation effect and promote dynamic recrystallization. With further increasing strain, θ becomes negative and then tends to zero. This is because that the work hardening and strain softening compete with each other and finally reach a dynamic equilibrium. Moreover, fine grains were formed at the particles, which provided a potential path for localized shear zones. During hot deformation process, the continuous dynamic recrystallization mechanism and grain boundary strengthening were dominated. The grain growth and the particles appearance became the primary mechanism of microstructure evolution. Besides, the optimal initial reduction of 32.3% is determined. These results can help guide the development of feasible processes to enhance strength and ductility.

Study of the microstructure and mechanical properties of Mg-rare earth alloys

Microstructure and Thermal Conductivity of As-Cast and As-Solutionized Mg–Rare Earth Binary Alloys

The effect of alloy composition on the microstructure and tensile properties of binary Mg-rare earth alloys

Microstructure and Mechanical Properties of Mg-Xy-1.5mm-0.4zr Alloys

Investigations on Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn-Zr-Nd Alloy

Effect of Substituting Nd for Y on Microstructure and Mechanical Properties of Mg-7Y-2Al Alloy

Influence of mixed rare earth elements(Y and Ce) on the microstructure and corrosion behaviour of Mg-4Al-3Ca alloy

Analysis and Discussion on the Room Temperature Microstructure and Properties of High Content Mixed Rare-Earth As-Cast AZ61 Magnesium Alloy

Study on the Strengthening Mechanism of Rare Earth Ce in Magnesium Alloys, Based on First-Principle Calculations and Electronegativity Theory

Study on the strengthening mechanism of rare earth yttrium on magnesium alloys

Modification of the Tensile Performance of an Extruded ZK60 Magnesium Alloy with the Addition of Rare Earth Elements

Microstructure Evolution Mechanism and Mechanical Properties of Mg-RE Alloy at a Critical Transition Temperature of Material Performance

Microstructure and mechanical properties of extruded ZK60 magnesium alloy containing rare earth

Microstructural Evolution and Mechanical Properties of Mg-5y-5gd-Xnd-0.5zr Magnesium Alloys at Different States

Research Progress on Microstructure and Mechanical Properties of Medical Rare-Earth Magnesium Alloys

Strengthening of Mg Alloy with Multiple RE Elements with Ag and Zn Doping via Heat Treatment

Effects of rare earth on microstructure and mechanical properties of AZ31B wrought magnesium alloy

Synergistic Effects of Cerium-Based Rare Earth Addition and Hot Deformation on the Microstructure and Mechanical Properties of Mg-0.5Zn-0.5Zr Magnesium Alloy

Effects of the Main Rare Earth Elements on Microstructure and Properties of Magnesium Alloys

Achieving superior elevated-temperature strength of Mg-12Gd-3Y alloys by Nd addition

Influence of Heat Treatment and Hot Extrusion on the Microstructure and Tensile Properties of Rare Earth Modified Mg-Zn Based Alloy