Abstract:Abstract Ion-induced secondary electron emission at a target surface is an essential mechanism for laboratory plasmas, i.e. magnetron sputtering discharges. Electron emission, however, is strongly affected by the target condition itself such as oxidation. Data of oxidized targets, however, are very sparse and prone to significant systematic errors, because they were often determined by modeling the complex behavior of the plasma. Thus, it is difficult to isolate the process of ion-induced electron emission from all other plasma-surface-interactions. By utilizing ion beams, the complex plasma environment is avoided and electron yields are determined with higher accuracy. In this study, ion-induced secondary electron emission coefficients (SEECs) of clean, untreated (air-exposed), and intentionally oxidized copper and nickel surfaces were investigated in such a particle beam experiment. Pristine and oxidized metal foils were exposed to beams of singly charged argon ions with energies of 0.2 keV - 10 keV. After the ion beam treatment, the surface conditions were analyzed by ex-situ x-ray photoelectron spectroscopy measurements. Further, a model for the electron emission of a partly oxidized surface is presented, which is in agreement with the experimental data. It was found, that oxidized and untreated/air-exposed surfaces do not show the same SEEC: for intentionally oxidized targets, the electron yields were smaller by a factor of 2 than for untreated/air-exposed surfaces. SEECs of oxides were found to be between the values for clean and for untreated metal surfaces. Further, the SEEC was at maximum for untreated/air-exposed surfaces and at minimum for clean surfaces; the electron yields of untreated/air-exposed and clean surfaces were in agreement with values reported in the literature.

The Dose Effect in Secondary Electron Emission

Secondary Electron Emission Yield Measurement of Dielectric Materials for Satellite Antenna

A Synthetic Semi-Empirical Physical Model of Secondary Electron Yield of Metals under E-Beam Irradiation

The Formula for the Secondary Electron Yield at High Incident Electron Energy from Silver and Copper

Effects of Electron Incident Angle on the Secondary Electron Yield for Polyimide

Theoretical study of secondary electron yield in energy range of 10~30 keV

Secondary Electron Emission from Surfaces with Small Structure

Secondary electron yield suppression using millimeter-scale pillar array and explanation of the abnormal yield–energy curve

The Effect of Magnetic Field on the Secondary Electron Yield in the Ultra-High Vacuum Environment

Ion-induced secondary electron emission of oxidized nickel and copper studied in beam experiments

Low Secondary Electron Yield Engineered Surface For Electron Cloud Mitigation

Research on the secondary electron yield of TiZrV-Pd thin film coatings

Report on Instrumentation and Methods for In-Situ Measurements of the Secondary Electron Yield in an Accelerator Environment

An extensive theoretical quantification of secondary electron emission from silicon

Measurements of the Secondary Electron Emission from Rare Gases at 4.2K

Measurement of True Secondary Electron Emission Yields of Kapton

Design and Research of Secondary Electron Emission Test Equipment with Low Electron Energy

Dynamic secondary electron emission in rough composite materials

A Combined Phenomenological Model for Secondary Electron Emission

THEORETICAL RESEARCH OF SECONDARY ELECTRON EMISSION FROM NEGATIVE ELECTRON AFFINITY SEMICONDUCTORS

The quantitative effect of thermal treatment on the secondary electron yield from air-exposed silver surface