Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

Enhancement in thermoelectric performance of hydrothermally synthesized Ca and Sb co-doped Bi 2 Te 3 nanostructures

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

Nanostructuring and improved performance of ternary Bi–Sb–Te thermoelectric materials

Effect of Doping and Annealing on Thermoelectric Properties of Bismuth Telluride Thin Films

Improvement in thermoelectric properties of Bi-Mg co-doped SnTe via band engineering and nanostructuring

Effect of Co-Doping on Thermoelectric Properties of n-Type Bi2Te3 Nanostructures Fabricated Using a Low-Temperature Sol-Gel Method

Highly Enhanced Thermoelectric and Mechanical Properties of Bi-Sb-Te Compounds by Carrier Modulation and Microstructure Adjustment

Enhanced Thermoelectric Properties of p-Type Bi 0.48 Sb 1.52 Te 3 /Sb 2 Te 3 Composite

Rare Earth Ytterbium Enhanced Thermoelectric Properties of P-Type Bi0.5Sb1.5Te3

High Power Factor and Thermoelectric Figure of Merit in Sb 2 Si 2 Te 6 through Synergetic Effect of Ca Doping

Synthesis and Thermoelectric Properties of Bi2te3 Based Nanocomposites

Highly Enhanced Thermoelectric Properties Of Nanostructured Bi2s3 Bulk Materials Via Carrier Modification And Multi-Scale Phonon Scattering

Ultralow lattice thermal conductivity and enhanced power generation efficiency realized in Bi2Te2.7Se0.3/Bi2S3 nanocomposites

Thermoelectric Properties of Hydrothermally Synthesized Bi2Te3−Sex Nanocrystals

Thermoelectric performance of p-type (Bi,Sb)2Te3 incorporating amorphous Sb2S3 nanospheres

Investigating Phase Transition and Morphology of Bi-Te Thermoelectric System

Realizing the Interface Tuned Thermoelectric Transport Performance in Bi2Te3-Based Hierarchical Nanostructures

Realizing high thermoelectric performance in Te nanocomposite through Sb2Te3 incorporation

Thermoelectric Properties of Hydrothermal Synthesized Bi-Te-Se Alloys

Synthesis and Thermoelectric Properties of Zn4Sb3/Bi0.5Sb1.5Te3 Bulk Nanocomposites

High performance of Mg3Bi1.5Sb0.5 based materials for power generation: Revealing the counter-intuitive effect of tuning Bi content on the thermoelectric properties