Simultaneous estimation of heat source strength of hot wire and thermal conductivity of material

Parth SathavaraAjit Kumar ParwaniParitosh Chaudhuria Department of Mechanical and Aero-Space Engineering,Institute of Infrastructure Technology Research and Management,Ahmedabad,Indiab Institute for Plasma Research,Gandhinagar,Indiac Homi Bhabha National Institute (HBNI),Mumbai,India
DOI: https://doi.org/10.1080/10407782.2024.2338918
2024-04-11
Numerical Heat Transfer Part A Applications
Abstract:The hot-wire (HW) technique is a widely used method for measuring the thermal conductivity ( k ) of insulation materials. However, there are some limitations to the applicability. For instance, inaccuracies may arise when the wire is assumed to be infinitely thin and long, or when the sample material is assumed to be an infinite medium. Additionally, the accuracy of k measurements relies on accurately specifying the heat source strength ( Q W ) generated by the HW. The modified conjugate gradient method (CGM) provides a solution to these limitations of the HW technique. In the modified CGM technique, a scaling factor based on the Levenberg-Marquardt method is utilized to address the low derivative and divergence issues of the traditional CGM. The current work simultaneously estimates Q W generated by the HW and k of the sample materials by using modified CGM. The investigation looked into the effect of sensor positioning relative to the HW and the introduction of artificial Gaussian error (noise) with a standard deviation of 0.01 °C , 0.02 °C and 0.1 °C into the simulated temperature measurements. The modified CGM estimates the unknown parameters accurately compared to the traditional CGM. The measurement location should be closer to the HW to obtain accurate estimation results. The noise level of 0.1 °C results in low accuracy of estimation of k and Q W for Plexiglas with one sensor, which can be enhanced by employing two sensors. Overall, the modified CGM algorithm proved to be a robust inverse algorithm that could be employed to estimate unknown parameters.
thermodynamics,mechanics
What problem does this paper attempt to address?