Abstract:The hot disk transient plane source (TPS) method is a widely used standard technique (ISO 22007-2) for the characterization of thermal properties of materials, especially the thermal conductivity, k. Despite its well-established reliability for a wide variety of common materials, the hot disk TPS method is also known to suffer from a substantial systematic errors when applied to low-k thermal insulation materials. Here, we present a combined numerical and experimental study on the influence of the geometry of hot disk sensor on measured value of low-k materials. We demonstrate that the error is strongly affected by the finite thickness and thermal mass of the sensor's insulation layer was well as the corresponding increase of the effective heater size beyond the radius of the embedded metal heater itself. We also numerically investigate the dependence of the error on the sample thermal properties, confirming that the errors are worse in low-k samples. A simple correction function is also provided, which converts the apparent (erroneous) result from a standard hot disk TPS measurement to a more accurate value. A standard polyimide sensor was also optimized using both wet and dry etching to provide more accurate measurement directly. Experimentally corrected value of k for Airloy x56 aerogel and a commercial silica aerogel using the numerical correction factor derived based on the standard TPS sensor is in excellent agreement with the directly measured value from the TPS sensor using the optimized polyimide sensor. Both of these methods can reduce the errors to less than 4% as compared to around 40% error of overestimation from raw values measured with the pristine sensor. Such results show that both the numerical correction to a pristine senor or an optimized sensor are capable of providing highly accurate value of thermal conductivity for such materials.

Correct Use of the Transient Hot-Wire Technique for Thermal Conductivity Measurements on Solids

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

Theoretical and Experimental Study on Transient Measurement of Wood Thermal Properties

The Boundary Induced Error on the Measurement of Thermal-Conductivity by Transient Hot-Wire Method

A high-precision method to measure thermal conductivity of solids using reversible heat flux

Analysis of errors in the evaluation of parallel transient hot wire measurements by means of line heat source fits

Correct Use of the Guarded-Hot-Plate Method for Thermal Conductivity Measurements on Solids

Use of a Needle Probe to Measure the Thermal Conductivity of Electrically Conductive Liquids at High Temperatures

Short Hot Wire Technique for Measuring Thermal Conductivity and Thermal Diffusivity of Various Materials

A Micromachined Device Using Transient Hot-Wire Method For High Accuracy Thermal Conductivity Measurement Of Semi-Rigid Materials

A High-Precision Instrumentation of Measuring Thermal Contact Resistance Using Reversible Heat Flux

Influence of Thermostatting on Nonequilibrium Molecular Dynamics Simulations of Heat Conduction in Solids.

Quantitative Measurement of Thermal Conductivity by SThM Technique: Measurements, Calibration Protocols and Uncertainty Evaluation

Numerical Approach for the Theory of Harmonic Self-Heating Technique to Measure Thermophysical Properties of Suspended Thin Samples

Investigation and Optimization of the Hot Disk Method for Thermal Conductivity Measurements up to 750 °C

Simultaneous measurements of the specific heat and thermal conductivity of suspended thin samples by transient electrothermal method.

Basic nanoconvective flow for transient hot wire experimental method

Hassle-free Approach to Thermal Transport Measurements Using Spatial-Temporal Temperature Data

Long Short Hot-Probe Method for Determining Thermophysical Properties

Analysis and Improvement of the Hot Disk Transient Plane Source Method for Low Thermal Conductivity Materials

Automated system for measuring thermal conductivity of solid materials