Abstract:<p>Full-flow penetrometers (ball and T-bar) are widely used for measurements of strength characteristics of clayey soils in offshore field investigations and laboratory tests. However, the accuracy of the estimated undrained shear strength is hampered by: (1) the drastic variation of the bearing factor for the penetrometer at shallow and transitional penetration depths where full-flow mechanisms are not achieved; and (2) the strain-softening of the soil, which results in a degradation of the estimated strength. This study conducted LDFE analyses to simulate the entire penetration process of full-flow penetrometers in strain-softening soils from shallow to deep embedment depths. Parametric studies were performed to investigate the effects of varied factors on the bearing factor and failure mechanism during the penetrometer penetration. Based on the LDFE analyses, empirical formulas are established to represent the critical penetration depths in the strain-softening soil, which are used to correct the bearing factor at shallow penetration depths. The discrepancies of the transitional failure mechanism and the trapped cavity bearing factor between ball and T-bar are emphasized. Finally, a back-analyses framework is proposed to estimate the strength parameters (including the original undrained shear strength prior to any strain-softening, and the strain-softening parameters) based on the measurements of the penetrometer during the first penetration from shallow to deep embedment depths. Through a series of model tests, the reliability of the back-analyses framework is validated.</p>

Simulation of T-bar penetration in soft clay with adhesive contact

Modelling T-bar Penetration in Soft Clay Using Large-Displacement Sequential Limit Analysis

Assess the Effects of Loading Rate and Interface Roughness on T-bar Penetration Resistance

Strain softening parameters estimation of soft clay by T-bar penetrometers

A novel T-bar test method ensuring full-flow mechanism in stiffer clay

3-D Numerical Simulation for Large-Diameter Cast-<i>In Situ</i> Tubular Pile

3-D Numerical Simulation for Large-Diameter Cast-In-Situ Tubular Pile

Centrifugal Model Test and Numerical Analysis of Deformation and Stability of Seawall on Soft Clay

Containment Tests and Analysis of Soft Wall Casing Fabricated by Wrapping Kevlar Fabric Around Thin Metal Ring

Soil Deformation and Erosion Near Mooring Chains in Clay Based on Cyclic T-Bar Tests

The Strength Assessment for T-bar Penetrometer Tests at Shallow Embedment in Clay considering Strain Softening

Numerical modeling of free-falling spherical penetrometer–clay–water interactions

Coupled analysis of full flow penetration problems in soft sensitive clays

Interpreting T-bar tests in ultra-soft clay

Interpreting strength parameters of strain-softening clay from shallow to deep embedment using ball and T-bar penetrometers

Experimental and Numerical Investigation on the Tensile Fracture of Compacted Clay

Undrained shear strength of clays measured by T-bar penetrometer in centrifuge

Modeling Temperature-Dependent Behavior of Soft Clay

Modelling the degradation of penetration resistance during cyclic T-bar tests in a Gulf of Mexico clay

Deep cavity flow mechanism of pipe penetration in clay