Abstract:Previous studies on laterally loaded piles in clay have mainly focused on flexible and rigid piles. Little attention has been paid to semi-rigid piles (whose pile–soil stiffness lies somewhere between those of rigid and flexible piles), which may behave as either flexible piles or rigid piles, depending on the change in soil stiffness during cycling. This study aims to understand the cyclic lateral response of a repeatedly loaded semi-rigid pile in soft clay and the failure mechanisms of the soil around the pile, through a series of centrifuge model tests and three-dimensional finite element analyses using an advanced hypoplastic clay model. Numerical parametric studies were also performed to investigate the evolution of soil flow mechanisms with increasing pile rigidity. It is revealed that the semi-rigid pile behaved as if it were a flexible pile (i.e., flexural deformation dominated) during the first few cycles, but tended to behave like a rigid pile (i.e., rotational movement prevailed) during subsequent cycles, which progressively softened the surrounding soil. As a result, the mechanisms of soil flow around the semi-rigid pile exhibited an intermediate behaviour combining the mechanisms of both flexible and rigid piles. Three distinctive mechanisms were identified: a wedge-type mechanism near the surface, a full-flow mechanism (within the transverse sections) near the middle of the pile, and a rotational soil flow mechanism (in the vertical symmetrical plane of the pile) near the lower half of the pile. By ignoring the rotational soil flow mechanism, which has a much lower resistance than the full-flow mechanism, the American Petroleum Institute code (published in 2007) underestimated the cyclic bending moment and the lateral pile displacement by 10% and 69%, respectively. Application of jet grouting around the semi-rigid pile at shallow depth significantly altered the soil flow mechanism (i.e., it was a solely wedge-type mechanism around the grouted zone).

Modelling the degradation of penetration resistance during cyclic T-bar tests in a Gulf of Mexico clay

A Strength Degradation Model of Saturated Soft Clay and Its Application in Caisson Breakwater

Modelling T-bar Penetration in Soft Clay Using Large-Displacement Sequential Limit Analysis

Undrained Cyclic Loading Behavior of Stiff Eocene-to-Jurassic Plastic, High-Ocr Clays

Assess the Effects of Loading Rate and Interface Roughness on T-bar Penetration Resistance

Centrifuge Modelling of Lateral Cyclic Behaviour of a Tetrapod Piled Jacket in Soft Clay

Experimental Study on Vertical and Lateral Behaviour of Open Caisson Foundations in Clay

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

Soil Deformation and Erosion Near Mooring Chains in Clay Based on Cyclic T-Bar Tests

Numerical Modelling of Pipe-Soil Interaction for Marine Pipelines in Sandy Seabed Subjected to Wave Loadings

Modeling Cyclic Embedment of Deep-Water Pipelines Using Large Displacement Limit Analysis

Coupled analysis of full flow penetration problems in soft sensitive clays

Interpretation of T-bar penetrometer tests at shallow embedment and in very soft soils

Assessment of Seabed Trench Formation Based on Marine Sediment Properties and Chain-Bar Penetration Tests

Theoretical framework for predicting accumulation of soil berms and peak sliding resistance for tolerably mobile foundations

Undrained cyclic shear strength and stiffness degradation of overconsolidated soft marine clay in simple shear tests

Development of cyclic p–y curves for laterally loaded pile based on T-bar penetration tests in clay

Energy-based Evaluation of Undrained Cyclic Behavior of Marine Soft Clay under Multidirectional Simple Shear Stress Paths

Centrifuge testing of a tolerably mobile subsea foundation: exploring the effect of soil type on the evolution of whole-life resistance and settlement

Cyclic Lateral Response and Failure Mechanisms of Semi-Rigid Pile in Soft Clay: Centrifuge Tests and Numerical Modelling