Abstract:Copper as well as copper base composites reinforced with coated and uncoated 1 wt% diamond, graphite particles or short carbon fibers are prepared by powder metallurgy process. The reinforcement particles were encapsulated with silver as well as copper layer by using the electroless deposition technique to investigate the influence of the reinforcement surface coating on the microstructure, density, electrical and thermal properties of the sintered samples. The coated and the uncoated powders were cold compacted at 600 MPa, and then sintered at 1173 K (900°C) for 2 h under hydrogen atmosphere. The phase composition, morphology and microstructure of the prepared powders as well as the copper base sintered composites were investigated using X-ray diffraction analysis (XRD) and Scanning Electron Microscope (SEM) equipped with an Energy Dispersive Spectrometer (EDS) respectively. The density of the sintered composites was measured by Archimedes method. The copper base consolidated composites had a density up to 96% and the reinforcement coated particles were distributed uniformly within the copper matrix better than the uncoated one. The electrical resistivity at room temperature and the heat transfer conduction of the produced samples were measured in a temperature range between 323 K (50°C) and 393 K (120°C). The results observed that the sintered materials prepared from the coated powder have lower electrical resistivity than the sintered materials prepared from the mixed powders. On the other hand the thermal conductivity values were calculated using the heat transfer conduction values by means of the Fourier formula. The results observed that the thermal conductivity of copper is (391 W/m·K), 1 wt% diamond/Cu is (408 W/m·K), 1 wt% graphite coated silver/Cu is (393 W/m·K), 1 wt% Cu coated short carbon fiber/Cu is (393 W/m·K), graphite/Cu is (383 W/m·K) and short carbon fiber/Cu is (382 W/m·K). The obtained composites are expected to be suitable for heat sink applications. The heat transfer testing experiments were done. The forced convection of the present work was done and compared with the previous work in the literature, and satisfactory agreement was achieved.

Advanced composite materials with tailored thermal properties for heat sink applications

Fabrication, Microstructure, Thermal and Electrical Properties of Copper Heat Sink Composites

Micro Heat Sink Structure with High Thermal Conductive Composite Via Micromachining Process

Cold Sprayed Copper-Diamond Composites for Thermal Management of Semiconductor Packages

Fabrication of diamond/copper composite thin plate based on a single-layer close packed diamond particles network for heat dissipation

Low Thermal Expansion Metal Composite-Based Heat Spreader for High Temperature Thermal Management

Quantitative and Qualitative Analysis of Advanced Aluminum Composites for Heat Transfer Properties

Carbon/Aluminum Composites with High Thermal Conductivity for Thermal Management Applications

High thermal conductive copper/diamond composites: state of the art

Study on radar electronic module cooling by using diamond/copper composites

Interfacial characterization and thermal conductivity of diamond/Cu composites prepared by two HPHT techniques

Copper–micrometer-sized diamond nanostructured composites

Microstructure of Cu-diamond Composites with Near-Perfect Interfaces Prepared Via Electroplating and Its Thermal Properties

Progress in the Copper-Based Diamond Composites for Thermal Conductivity Applications

Heat conduction and thermal expansion of copper–graphite composite as a heat sink

Development of High Thermal Conductivity Copper Alloys with Diamond Particle Additions

Net-shape forming process for diamond-copper composites with high thermal conductivity

Realizing ultrahigh thermal conductivity in bimodal-diamond/Al composites via interface engineering

Aluminium-Silicon Lightweight Thermal Management Alloys with Controlled Thermal Expansion

Development of light composite materials with low coefficients of thermal expansion

Fabrication of Titanium and Copper-Coated Diamond/Copper Composites via Selective Laser Melting