Abstract:Three-dimensional braided composite has a unique spatial network structure that exhibits the characteristics of high delamination resistance, damage tolerance, and shear strength. Considering the characteristics of braided structures, two types of high-performance materials, namely, aramid and carbon fibers, were used as reinforcements to prepare braided composites with different hybrid structures. In this study, the longitudinal and transverse shear properties of 3D braided hybrid composites were tested to investigate the influences of hybrid and structural effects. The damage characteristics of 3D braided hybrid composites under short beam shear loading underwent comprehensive morphological analysis via optical microscopy, water-logging ultrasonic scanning, and X-ray micro-computed tomography methods. It is shown that the shear toughness of hybrid braided composite has been improved at certain degrees compared with the pure carbon fiber composite under both transverse and longitudinal directions. The hybrid braided composites with aramid fiber as axial yarn and carbon fiber as braiding yarn exhibited the best shear toughness under transverse shear loading. Meanwhile, the composites with carbon fiber as axial yarn and aramid fiber as braiding yarn demonstrated the best shear toughness in the longitudinal direction. Due to the different distribution of axial and braiding yarns, the transverse shear property of hybrid braided structure excels over the longitudinal shear property. The failure modes of the hybrid braided composite under the two loading directions are considerably different. Under transverse loading, the primary failure mode of the composites is yarn fracture. Under longitudinal loading, the primary failure modes are resin fracture and fiber slip. The extensive interfacial effects and the good deformation capability of the hybrid braided composites can effectively prevent the longitudinal development of internal cracks in the pattern, improving the shear properties of braided composites.

Effects of loading rate and loading direction on the compressive failure behavior of a 2D triaxially braided composite

X-ray microtomography analysis of the damage mechanisms in 3D circular braided carbon fiber/epoxy resin composite tubes under axial impact compression

Analysis of in-plane compression failure mechanism in carbon fiber braided composite with different off-axial angles

Size-dependent mechanical behaviors of 3D woven composite under high strain-rate compression loads

Experimental characterization of failure behaviour for three-dimensional woven carbon/carbon composites under pin-loading

Experimental and numerical study of in-plane compressive properties and failure of 3D six-directional braided composites with large braiding angle

Investigation of parameterized braiding parameters and loading directions on compressive behavior and failure mechanism of 3D four-directional braided composites

Experimental study on the fabrication, high-temperature properties and failure analysis of 3D seven-directional braided composites under compression

Anisotropic failure analysis of 2.5-D braided composites under compression

Compressive Experimental Investigation of 3D 4-Directional Braided Composites Board on Mesoscopic Failure Mechanism

Damage and failure analyses of 3D4d braided composite shafts under torsional load and the effects of braid processing parameters on their torsional properties

Quasi-static Axial Crushing and Transverse Bending of Double Hat Shaped CFRP Tubes

Experimental Investigation of Z-pin Insertion Angles on the Mechanical Behavior and Failure Mechanism of Compression after Impact for CFRP Laminates

High strain rate impact effect and failure behavior of 3D six-directional braided composites

Experimental investigation on high-velocity impact damage and compression after impact behavior of 2D and 3D textile composites

Off-axial Angle Sensitivity of 3D Orthogonal Woven Composite Failure Behavior Subjected to In-Plane Compressive Loading

Mechanical Behavior and Failure Mode of Woven Carbon/epoxy Laminate Composites under Dynamic Compressive Loading

Short Beam Shear Behavior and Failure Characterization of Hybrid 3D Braided Composites Structure with X-ray Micro-Computed Tomography

Study on in-plane compression properties and numerical modeling of three dimensional five-directional braided composites

Investigating the Effects of Contact Area and Chamfering on the Failure Behavior of Plain Woven Composite-Metal T-joints

Compressive Failure of Carbon/Epoxy Laminate Composites under High Impact Loading