Abstract:The soil in front of a shield tunnel face can be pushed toward the ground surface if the support pressure is higher than the threshold that causes blow-out failure of the tunnel face. Most of the failure mechanisms used in the upper-bound analysis of a tunnel face have been derived from rigid-block failure mechanisms that are inconsistent with the failure mode observed in actual engineering practice. This article describes the construction of a new blow-out failure mechanism that is characterized by an arbitrary curve. Based on this failure mechanism and the Hoek–Brown (H-B) nonlinear failure criterion, an objective function that can be used to derive the upper-bound solution of the failure surface for a tunnel face is established in the framework of the upper-bound theorem. Using a variational approach, the equation of the failure surface that makes the objective function reach an extremum is obtained. On the basis of the analytical equation of the failure surface, the shapes of the failure surfaces for different parameters are plotted. By studying the influence of various parameters on the shape of failure surfaces, the changing laws of the shape of the failure surface for different parameters are obtained. To evaluate the validity of the upper-bound solution, the analytical results are compared with the numerical results provided by finite-difference software. By converting the parameters of the H-B failure criterion represented by normal and shear stresses into the parameters of the H-B failure criterion represented by the major and minor principal stresses, a comparison is made for equivalent conditions. The failure surface derived from the upper calculation and the shear-failure surface provided by the numerical simulation are found to be in agreement, which indicates that the method proposed is valid.

Study on potential collapse of deep-buried tunnel induced by local overbreak obeying Hoek-Brown failure criterion

Instability Mechanism of Shallow Tunnel in Soft Rock Subjected to Surcharge Loads

Upper Bound Analysis of Tunnel Face Stability in Layered Soils

Limit Analysis of Shallow Tunnels Collapse Problem with Optimized Solution

Collapse analysis of tunnel floor in karst area based on Hoek-Brown rock media

Closed-form solutions for collapse mechanisms of tunnel crown in saturated non-uniform rock surrounds

Upper Bound Limit Analysis of Deep Tunnel Face Support Pressure with Nonlinear Failure Criterion under Pore Water Conditions

Three-Dimensional Upper Bound Limit Analysis on the Collapse of Shallow Soil Tunnels considering Roof Stratification and Pore Water Pressure

Study on Collapse Mechanism in Loose Wall Rock of Shallow Tunnel under Rainfall

Enhanced Theoretical Approach for Predicting the Tunnel Response Due to Deep Excavation Above

Failure analysis and countermeasures of highway tunnel crossing fault fracture zone in coal-bearing strata: A case study

Three-dimensional stability analysis of tunnel face considering the upper partial failure in layered rock masses

Analytical Method for Predicting Tunnel Heave Due to Overlying Excavation Considering Spatial Effect

Limit Analysis of Collapse Mechanisms for Tunnel Roofs Subjected to Pore Water Pressure: A Numerical Approach

Improved Theoretical Solutions for Estimating the Tunnel Response Induced by Overlying Excavation

Limit Analysis for the Face Stability of a Shallow-Shield Tunnel Based on a Variational Approach to the Blow-Out Failure Mode

Three-Dimensional Analytical Solution for Passive Limit Support Pressure During Shield Tunnelling

Study on Collapse Mechanism at Tunnel Export and Its Prevention Measure

Calculation Method of Loose Pressure in Surrounding Rock Mass

Failure mechanism and countermeasures of rainfall-induced collapsed shallow loess tunnels under bad terrain: A case study

Analysis of Factors Influencing Tunnel Block Collapse in Blocky Rock Masses: Insights from Large-Scale Model Experiments and DDA Simulations