Abstract:Abstract The construction of tunnel portal not only has to face the challenges of complex geological conditions such as shallow buried and asymmetrically loaded, but also needs to consider the adverse effects of factors such as the layout form of the tunnel. Thus, the construction of portal has always been the difficulty and focus of tunnel engineering construction. Under the coupling of multiple adverse factors such as complex geological conditions and special layout form, the tunnel portal is prone to excessive deformation, supporting structures cracking and even collapse during the excavation. In this study, a shallow buried and asymmetrically loaded tunnel with small clear-distance in northwest China was taken as an engineering case. Aiming at the distresses of slope instability, peeling off and block falling of primary support concrete and cracking of secondary lining concrete in the tunnel portal construction, combined with field investigation, statistical analysis, numerical simulation and deformation monitoring, the failure mechanism of supporting structures was deeply studied, and the corresponding treatment measures were proposed. The research results indicated that the loose and broken gravel soil in the shallow buried section, asymmetrical loading, surface water infiltration, and short construction spacing between two tunnels were the main triggers of supporting structures failure. Affected by the topographic bias, the loose load generated by the surrounding rock on the deep buried side squeezed the entire tunnel to the shallow buried side after the portal excavation. And this deformation trend became more significant after the gravel soil was deteriorated by water immersion. The retaining wall produced a clockwise rotation deformation around the wall corner in the process of limiting the tunnel deviation, and the local wall body cracked due to the excessive tensile stress. The primary support concrete and secondary lining concrete produced excessive asymmetrical deformation because of the significant asymmetrical loading. The concrete with excessive deformation was cracked by obvious tensile or shear stress. The following tunnel excavation had a significant negative impact on the stability of the prior tunnel. Combining the failure mechanism of the supporting structures and the characteristics of the continuous development of cracks, the treatment measures of ‘stabilize the stratum first and then treat the cracks’ were proposed, including the backfilling and tamping the shallow buried side at tunnel portal, reinforcing the interlaid rock by ground surface grouting, setting intercepting ditch at the slope top, staggering a certain safe excavation distance between the following tunnel and the prior tunnel. The field monitoring and patrol inspection results indicated that the proposed treatment measures had achieved the expected results. The research results can provide corresponding construction experience and suggestions for similar projects in the future.

Failure mechanism and countermeasures of rainfall-induced collapsed shallow loess tunnels under bad terrain: A case study

Instability Mechanism of Shallow Tunnel in Soft Rock Subjected to Surcharge Loads

Failure mechanism and treatment measures of supporting structures at portal for a shallow buried and asymmetrically loaded tunnel with small clear-distance

Failure mechanism and treatment measures of supporting structures at the portal for a shallow buried and asymmetrically loaded tunnel with small clear-distance

Failure mechanism and countermeasures of limestone tunnel collapse due to rainfall under complex terrain: A case study

Collapse development characteristics of a vertical loess slope and its influence on adjacent tunnels

Analysis of loess water migration regularity and failure response of tunnel structure under rainfall environment

Failures in loess slope-tunnel system: An overview of trigging sources, acting mechanism and mitigation strategies

Study on Collapse Mechanism at Tunnel Export and Its Prevention Measure

Physical modeling of wetting-induced collapse of shield tunneling in loess strata

Effect of the longitudinal local wetting-induced collapse on tunnel structure in loess strata

Mechanism and prevention of “Closed Door” collapse in tunnel construction: A case study

Characteristics and treatment measures of tunnel collapse in fault fracture zone during rainfall: A case study

Research on subway shield tunnel induced by local water immersion of collapsible loess

Failure analysis and treatments of a loess tunnel being constructed in ground fissure area

Erosion characteristics of loess tunnels on the Loess Plateau: A field investigation and experimental study

Influence spatial behavior of surface cracks and prospects for prevention methods in shallow loess tunnels in China

Failure analysis and countermeasures of highway tunnel crossing fault fracture zone in coal-bearing strata: A case study

Study on Collapse Mechanism in Loose Wall Rock of Shallow Tunnel under Rainfall

Model test study on the influence of the collapsibility of loess stratum on an urban utility tunnel

Three-Dimensional Upper Bound Limit Analysis on the Collapse of Shallow Soil Tunnels considering Roof Stratification and Pore Water Pressure