Abstract:The extraction of lithium from liquid minerals, such as salt lake brines and underground brines, has garnered extensive interest due to its eco-friendly and cost-effective properties. However, the effectiveness of this method is constrained by the stability and capacity of the materials. Herein, a new-type inorganic carbon-supported H2TiO3 adsorbent was developed by a novel in-situ polymerization synchronous conversion strategy. It was found that when resorcinol and formaldehyde containing Li2CO3 and TiO2 were polymerized in-situ and then calcined at 973.15 K, the resin was successfully carbonized to obtain the carbon supporter with a low degree of disorder, and the Li2CO3 and TiO2 in the supporter were synchronously converted into Li2TiO3 and uniformly dispersed in the carbon matrix. Because of the large specific surface area and strong hydrophilicity of the carbon supporter, the material exhibited a maximum Li+ adsorption capacity of 52.14 mg & sdot;g(-1), which was far higher than that of inorganic composite materials reported at present. Even the equilibrium adsorption capacity for Li+ at a low concentration of 29.26 mg & sdot;L-1 reached 28.51 mg & sdot;g-( & sdot;1) . Following adsorption, the Li+ in the material was easily eluted by 0.25 mol & sdot;L-1 & sdot; L- 1 HCl, and the elution rate was more than 90 % within 2 h. Dynamic adsorption using a fixed-bed was also performed at 298.15 and 343.15 K, and the adsorption capacity for the same concentration of Li+ was 7.08 and 9.44 mg & sdot;g(-1), respectively. Because of the high capacity for low-concentration Li+ + and the promoting effect of temperature on adsorption, the material is well-suited for recovering Li(+ )from liquid resources, particularly from geothermal water with high temperatures and low Li+ concentrations.

Synthesis of porous fiber-supported lithium ion-sieve adsorbent for lithium recovery from geothermal water

Novel Lithium Ion-Sieve Spinning Fiber Composite of Pvdf-Hmo for Lithium Recovery from Geothermal Water

Synthesis of Polyporous Ion-Sieve and Its Application for Selective Recovery of Lithium from Geothermal Water

Inorganic Porous Carbon As the Supporter of H2TiO3 Via In-Situ Polymerization Synchronous Conversion for Lithium Recovery from Aqueous Solutions

Inorganic porous carbon as the supporter of H 2 TiO 3 via in-situ polymerization synchronous conversion for lithium recovery from aqueous solutions

A novel Co-doped H 2 TiO 3 spinning composite for efficient lithium recovery from alkaline lithium precipitation mother liquor

A Novel Co-doped H2TiO3 Spinning Composite for Efficient Lithium Recovery from Alkaline Lithium Precipitation Mother Liquor

Titanium-based ion sieve with enhanced post-separation ability for high performance lithium recovery from geothermal water

Porous Lithium Ion Sieves Nanofibers: General Synthesis Strategy and Highly Selective Recovery of Lithium from Brine Water

Novel LIS-Doped Mixed Matrix Membrane Absorbent with High Structural Stability for Sustainable Lithium Recovery from Geothermal Water

Lithium extraction from geothermal brine by granulated HTO titanium-based adsorbent with block-co-polymer poly (ethylene-co-vinyl alcohol) (EVAL) as binder

Recovery of Lithium from Brine with Different Degrees of Mineralization by Resorcinol/urea–formaldehyde Foam-Supported H2TiO3

Green Recovery of Lithium from Geothermal Water Based on a Novel Lithium Iron Phosphate Electrochemical Technique

Selective recovery of lithium from geothermal water by EGDE cross-linked spherical CTS/LMO

Highly selective separation of lithium with hierarchical porous lithium-ion sieve microsphere derived from MXene

Porous polyvinyl alcohol/polyacrylamide hydrogels loaded with HTO lithium-ion sieves for highly rapid and efficient Li + extraction

Hydrothermal synthesis and adsorption behavior of H4Ti5O12 nanorods along [100] as lithium ion-sieves

Structural/surficial dual regulated granular H2TiO3 lithium-ion sieves for lithium extraction from salt lake brine

Synthesis of Spherical Composite CMC-LTO-EGDE-ME for Lithium Recovery from Geothermal Water

DFT Calculation and Experiments for Li+/H+ Ion-Exchange on Titanium-Based Lithium Ion-Sieves

Hydrophilic surface-modified titanium-based lithium ion sieve adsorbents for efficient lithium extraction