Abstract:The electrical characteristics of Ni electrode-based metal-insulator-metal (MIM) capacitors have been investigated with atomic layer deposited ZrO2/SiO2/ZrO2 symmetric stacked-dielectrics. When the thickness of the stacked-dielectrics is fixed at 14 nm, the resulted capacitance density decreases from 13.1 fF/m(2) to 9.3 fF/m(2), and the dissipation factor is reduced from 0.025 to 0.02. By comparison of current-voltage (I-V) curves of different MIM capacitors, it is found that the leakage current density in the high voltage region decreases gradually with the increasing thickness of SiO2, and it does not exhibit clear change in the low voltage region. Meanwhile, the capacitors show different conduction behaviors under positive and negative biases with increasing the thickness of SiO2 from 0 to 2 nm. Under the positive bias, different I-V characteristics are demonstrated at high and low electric fields, respectively. However, a single I -V characteristic is dominant under the negative bias. Further, the conduction mechanisms of the capacitors are investigated under the electron bottom and top injection modes, respectively. It is found that the Poole-Frenkel emission and the trap-assisted tunneling are dominant in the high and low field regions, respectively, for the electron bottom injection; however, the trap-assisted tunneling is dominant in the whole field region for the electron top injection. These are attributed to the formation of a thin NiOx interfacial layer between the Ni bottom-electrode and the ZrO2 dielectric layer, as well as the existence of both deep and shallow level traps (0.9 and 2.3 eV) in the ZrO2 dielectric. Therefore, the level trap plays a key role in the electron conduction in the MIM capacitor under different electron injection modes and different electric fields.

Breakdown voltage and TDDB performance improvement by optimizing the PECVD dielectric film characteristics in MIM capacitors

Enhanced TDDB-Reliability of Ultra-Thin Zirconia Capacitors Featuring Al-doped Oxide Layers

Improvement in Leakage Current and Breakdown Field of Cu-Comb Capacitor Using a Silicon Oxycarbide Dielectric Barrier

High-Performance MIM Capacitors Using Zr-Sn-Ti-O Dielectrics Derived from Atomic Layer Deposition

Fabrication and properties of silicon nitride thin film MIM capacitor

Dielectric Properties Investigation of Metal–Insulator–Metal (MIM) Capacitors

High-temperature time-dependent dielectric breakdown of 4H-SiC MOS capacitors

High-Performance MIM Capacitors for a Secondary Power Supply Application

Improvement of Voltage Linearity and Leakage Current of MIM Capacitors with Atomic Layer Deposited Ti-Doped ZrO2 Insulators

High Density Al2O3/TaN-based Metal–insulator–metal Capacitors in Application to Radio Frequency Integrated Circuits

The study on metal-insulator-metal capacitor performance improvement

Ultrahigh Breakdown Strength of NaNbO3‐based Dielectric Ceramics for High‐voltage Capacitor Application

Demonstration and Characterization of 500 V MIM Capacitor with Al2O3 Dielectric Layer for Power Integrated Circuits

A comparison study of high-density MIM capacitors with ALD HfO2-Al2O3 laminated, sandwiched and stacked dielectrics

A comparison study of high-density MIM capacitors with ALD HfO/sub 2/-Al/sub 2/O/sub 3/ laminated, sandwiched and stacked dielectrics

The Gate Oxide Breakdown Failures of 4H-Sic MOS Devices

The Effects of Postdeposition Anneal and Postmetallization Anneal on Electrical Properties of TiN/ZrO2/TiN Capacitors

Lifetime of thin oxide and oxide-nitride-oxide dielectrics within trench capacitors for DRAMs

Dielectric Enhancement of Atomic Layer-Deposited Al2O3/ZrO2/Al2O3 MIM Capacitors by Microwave Annealing

Impact of Process on Gate Leakage Current and Time-Dependent Dielectric Breakdown Failure Mechanisms of 4H-SiC MOS Capacitors

Conduction Mechanisms of Mim Capacitors with Zro2/Sio2/Zro2 Stacked Dielectrics and Ni Electrodes