Abstract:This research aims to design and construct an electronic notice as an alternative to the traditional signpost parting on walls and billboards by providing practical, reliable and proper information dissemination. They consist of the following units, the power supply, voltage regulators, GSM modules, microcontroller, LED dot matrix display board, counter and subscriber identity module (SIM). The power supply comprises a 240/9 v ac 50 Hz step-down transformer rectifier filter and voltage regulations. AT89852, a low-power, high-performance CM05 8-bit microcontroller with 8 k bytes in-system programmable flash memory, is used in this design. A constant five v de is required to power microcontrollers and their associated input/output channel. GSM Modern is a wireless device that works with a GSM wireless network. The counter circuit of the device used to achieve this type of counting is the 5-stage Johnson decade counter. It is a typical chip in the 74HC555, with ten decoded outputs that go high one at a time. The assembler used for this research is MLAB version 5.7, downloaded from the microchip website. This window-based integrated development environment (IDE) software supports the PIC and other microcontrollers. The project constitutes both the software and hardware section for successful implementation. Operation more focus was given to the contribution of the system hardware. For verification of proper functionality of the message board, variation tests carry out and their results. Each component was carefully tested, and hardware troubleshooting and software debugging were carried out. The message was sent, and it appeared and started moving from left to right. In conclusion, by introducing the concept of wireless technology in communication, we can make our communication more efficient and faster with excellent efficiency, and the message can be displayed with less error and maintenance. This model can be used efficiently in establishments like colleges where in-order and special discounts can be displayed simultaneously at all branches. It is therefore recommended as a conventional model can say more than one message at a time LEDS have a limitation on size and a good number of characteristics. These can be replaced with large LED display boards, which not only catch bulb display attributes in a moving position one after another.

The Design Of Electronic Billboard Based On TMS320F2812

Design of Electronic Billboard Based on AT89S51

Design and Application of an Image Processing System Based on TMS320VC5416

Dynamic Chinese Character Display Using Microcontroller-Based LED Dot Matrix Billboard

Design and Simulation of Dynamic Display LED Based on Single-chip Microcontroller

Design of A Microencapsulated Electronic Ink Display

The Design of Electronic Display Screen of Interest Rate, Chinese Characters,Calendar Clock

Design and Construction of a Microcontroller Based Electronic Moving Message Display

Design of New LED Curtain Wall Controller and Its Effect in Architectural Decoration

The application of DSP in the display of the big LED screen

Study on Display Design of MEMS-CAD

Electrophoretic Display Controller Integrated With Real-Time Halftoning and Partial Region Update

Display and Drawing Methods for LCD Module

A scheme of video signal processing system for field emission display based on dsp and fpga devices

Design of Full_Color LED Display Panel System Based on STM32

Design and Construction of a Modified SMS-Based Electronic Notice Board

Design of Display Measurement System Based on AT89C52 and CPLD

Design of LCD Controller Based on DSP and CPLD Chip

Software Design and Implementation of Liquid Crystal Displayed Tachistoscope

Research of wave display system based on 12864 LCD

A design of LED full color display screen control system based on FPGA