Abstract:This research aims to design and construct an electronic notice as an alternative to the traditional signpost parting on walls and billboards by providing practical, reliable and proper information dissemination. They consist of the following units, the power supply, voltage regulators, GSM modules, microcontroller, LED dot matrix display board, counter and subscriber identity module (SIM). The power supply comprises a 240/9 v ac 50 Hz step-down transformer rectifier filter and voltage regulations. AT89852, a low-power, high-performance CM05 8-bit microcontroller with 8 k bytes in-system programmable flash memory, is used in this design. A constant five v de is required to power microcontrollers and their associated input/output channel. GSM Modern is a wireless device that works with a GSM wireless network. The counter circuit of the device used to achieve this type of counting is the 5-stage Johnson decade counter. It is a typical chip in the 74HC555, with ten decoded outputs that go high one at a time. The assembler used for this research is MLAB version 5.7, downloaded from the microchip website. This window-based integrated development environment (IDE) software supports the PIC and other microcontrollers. The project constitutes both the software and hardware section for successful implementation. Operation more focus was given to the contribution of the system hardware. For verification of proper functionality of the message board, variation tests carry out and their results. Each component was carefully tested, and hardware troubleshooting and software debugging were carried out. The message was sent, and it appeared and started moving from left to right. In conclusion, by introducing the concept of wireless technology in communication, we can make our communication more efficient and faster with excellent efficiency, and the message can be displayed with less error and maintenance. This model can be used efficiently in establishments like colleges where in-order and special discounts can be displayed simultaneously at all branches. It is therefore recommended as a conventional model can say more than one message at a time LEDS have a limitation on size and a good number of characteristics. These can be replaced with large LED display boards, which not only catch bulb display attributes in a moving position one after another.

Design of Electronic Billboard Based on AT89S51

The Design Of Electronic Billboard Based On TMS320F2812

P-232L: Late-News Poster: New Results on Bistable Photoaligned Ferroelectric LCDs: Grey Scale Generation, Stabilization and Passive Driving Scheme

Design and Simulation of Dynamic Display LED Based on Single-chip Microcontroller

Dynamic Chinese Character Display Using Microcontroller-Based LED Dot Matrix Billboard

Design of Lattice Electron Display Screen Based on SPCE061A

Serial Communication Controlling LCM Displaying Based on AT89S52

The Design and Application of an Altimeter System Based on 89C52

Design of Display Measurement System Based on AT89C52 and CPLD

Speed Control Scheme of Large-LED Display Screen

Design and Construction of a Microcontroller Based Electronic Moving Message Display

Interface Design of 89C51 and LCD Module MSC-G12864

Low Power Consumption Design for LCD Panel

Design and Construction of a Modified SMS-Based Electronic Notice Board

Circuit Design of Single Panel Color LCOS Microdisplay Chip

Design of LED Timing Dimmer Based on DS1302 and Attiny13

Design of Full Color Static and Dynamic Image by OLED Display Based on Single-chip Controlling

Design of New LED Curtain Wall Controller and Its Effect in Architectural Decoration

Development of Laboratory Wireless Information Display

The Design of Display System for OLED Based on ARM

Design and Practice in Experiment of 4-Digit LED 8-Gray Scale Display