Abstract:Atmospheric-pressure plasma-enhanced spatial atomic layer deposition (PE-s-ALD) is considered a promising technique for high-throughput and low-temperature deposition of ultrathin films for applications where volume and costs are particularly relevant. The number of atmospheric-pressure PE-s-ALD processes developed so far is rather limited, and the fundamental aspects of their growth mechanisms are largely unexplored. This work presents a study of the atmospheric-pressure PE-s-ALD process of Al 2 O 3 using trimethylaluminum [TMA, Al(CH 3 ) 3 ] and Ar–O 2 plasma within the temperature range of 80–200 °C. Thin-film analysis revealed low impurity contents and a decreasing growth-per-cycle (GPC) with increasing temperature. The underlying chemistry of the process was studied with a combination of gas-phase infrared spectroscopy on the exhaust plasma gas and optical emission spectroscopy (OES) on the plasma zone. Among the chemical species formed in the plasma half-cycle, CO 2 , H 2 O, CH 4 , and CH 2 O were identified. The formation of these products confirms that the removal of CH 3 ligands during the plasma half-cycle occurs through two reaction pathways that have a different temperature dependences: (i) combustion reactions initiated by O 2 plasma species and leading to CO 2 and H 2 O formation and (ii) thermal ALD-like reactions initiated by the H 2 O molecules formed in pathway (i) and resulting in CH 4 production. With increasing temperature, the dehydroxylation of OH groups cause less TMA adsorption which leads to less CO 2 and H 2 O from the combustion reactions in the plasma step. At the same time, the higher reactivity of H 2 O at higher temperatures initiates more thermal ALD-like reactions, thus producing relatively more CH 4 . The CH 4 can also undergo further gas-phase reactions leading to the formation of CH 2 O as was theoretically predicted. Another observation is that O 3 , which is naturally produced in the atmospheric-pressure O 2 plasma, decomposes at higher temperatures mainly due to an increase of gas-phase collisions. In addition to the new insights into the growth mechanism of atmospheric-pressure PE-s-ALD of Al 2 O 3 , this work presents a method to study both the surface chemistry during spatial ALD to further extend our fundamental understanding of the method.

Study of Mid-Pressure Ar Radiofrequency Plasma Used in Plasma-Enhanced Atomic Layer Deposition of α-Al2O3

Temperature study of atmospheric-pressure plasma-enhanced spatial ALD of Al2O3 using infrared and optical emission spectroscopy

Plasma-Assisted ALD of Al2O3 at Low Temperatures: Reaction Mechanisms and Material Properties

In situ reaction mechanism studies of plasma-assisted atomic layer deposition of Al2O3

Innovative low temperature plasma approach for deposition of alumina films

Study of the surface species during thermal and plasma-enhanced atomic layer deposition of titanium oxide films using in situ IR-spectroscopy and in vacuo X-ray photoelectron spectroscopy

Effect of a Spatially Fluctuating Heating of Particles in a Plasma Spray Process

Optical diagnostics and mass spectrometry on the afterglow of an atmospheric pressure Ar/O$_2$ radiofrequency plasma used for polymer surface treatment

Effects of Spray Parameters on the Microstructure and Property of Al2O3 Coatings Sprayed by a Low Power Plasma Torch with a Novel Hollow Cathode

Feasible Power for DLC Deposition on Alumina by RF-biased Inductively Coupled Plasma: Effect of Atmospheric Parameters

Characterizing the Stability of Ultra-Thin Metal Oxide Catalyst Films in Non-thermal Plasma CO2 Reduction Reactions

Preliminary Study on Applications of an Atmospheric-Pressure Argon Plasma Discharge with a Single-Electrode Configuration

Temporal and Spatial Dynamics of Laser-Induced Aluminum Plasma in Argon Background at Atmospheric Pressure: Interplay with the Ambient Gas

Spectroscopic Characterization of the Plasma Generated During the Deposition of AlxGa1−xN Films by Pulsed Laser Co-Ablation of Al and GaAs Targets in Electron Cyclotron Resonance Nitrogen Plasma

Plasma-enhanced and thermal atomic layer deposition of Al2O3 using dimethylaluminum isopropoxide, [Al(CH3)2(μ-OiPr)]2, as an alternative aluminum precursor

Properties of high-quality LaAlO3 film deposited by in-situ plasma-enhanced-atomic-layer-deposition

Effect of Spraying Parameters on the Microstructure and Mechanical Properties of Micro-Plasma Sprayed Alumina-Titania Coatings

Experimental and Simulation Investigation of Electrical and Plasma Parameters in a Low Pressure Inductively Coupled Argon Plasma

Atomic Layer Deposition of Noble Metals – New Developments in Nanostructured Catalysts

Plasma-assisted atomic layer deposition of transition metals and their carbides

Diamond-like Carbon Thin Films Prepared by ECR Argon Plasma Assisted Pulsed Laser Deposition