Abstract:Supported catalysts were prepared by interaction of TiCl4 and VOCl3 vapours with surface OH-groups of amorphous SiO2. These catalysts, combined with (C2H5)2AlCl and (C4H9)1,5(C8H17)0.5Mg, are highly active catalyst systems for polymerization of ethylene. It is shown that by careful selection of catalyst concentration and mole ratio of catalyst components in suspension polymerization, ultra-high molecular weight polyethylene (UHMWPE) with molecular weights from 1.2×106 to 5.3×106 can be obtained. Titanium and vanadium containing catalyst systems without carrier was also studied for comparison. The rate of the polymerization process was studied for the catalysts giving high productivity. The slowest polymerization was observed with supported vanadium catalyst and UHMWPE obtained was with molecular weight 5.3×106. The molecular structure of the polymers synthesized was studied by IR spectroscopy after ageing in air. It is shown that the higher content of vinyl groups in UHMWPE synthesized with unsupported titanium catalyst and the higher content of carbonyl groups in UHMWPE with highest molecular weight decreased the thermal stability of the polymers. The thermal and thermodynamic characteristics of the UHMWPE obtained were studied by derivatographic analysis and differential scanning calorimetry. The primary thermooxidative and main chain destruction of UHMWPE obtained with supported titanium catalyst was found to begin at higher temperatures. This determined better physicomechanical properties of the polymers studied.

SYNTHESIS OF ULTRA-HIGH MOLECULAR WEIGHT POLYETHYLENE WITH HIGH MELTING POINT IN OCTAFLUOROBUTANE MEDIUM

Synthesis of Ultra-High-Molecular-Weight Polyethylene with an Elevated Melting Point in an Octafluorobutane Medium

PREPARATION OF ULTRA HIGH MOLECULAR WEIGHT POLYETHYLENE USING STRUCTURED NANOPARTICAL ZIEGLER-NATTA CATALYSTS

Rheology of Ultra High Molecular Weight Polystyrene

Thermal and Mechanical Properties of Ultrahigh-Molecular-Weight Ethylene/1-Hexene Copolymers Prepared by Living Polymerization with Fluorinated Bis(Phenoxy-Imine) Titanium(Iv) Catalyst

Synthesis of Ultrahigh-Molecular-weight Ethylene-1-hexene Copolymers with High Hexene Content Via Living Polymerization with Fluorinated Bis(phenoxy-Imine) Titanium(iv).

Studies on Nonisothermal Crystallization of Ultra–high Molecular Weight Polyethylene in Liquid Paraffin

Preparation of ultrahigh molecular weight ethylene/1-octene block copolymers using ethylene pressure pulse feeding policies

Synthesis of Molecular Weight Controllable Bimodal Polyethylene from Fluorinated FI–Ti Catalyst Coupled with ZnEt2

UHMWPE with Short‐chain Branches Synthesized by Alkenyl Substituted Phenoxy–imine Catalysts in Ethylene Polymerization

Preparation of Microporous Ultra High Molecular Weight Polyethylene (uhmwpe) by Thermally Induced Phase Separation of A Uhmwpe/Liquid Paraffin Mixture

Preparation of Polyethylene Elastomers with Increased High Molecular Weight and Nearly Perfect Strain Recovery by Steric Control of Asymmetric Α-Diimine Nickel Catalyst

Synthesis of Well-Defined Polystyrene with Molar Mass Exceeding 500 kg/mol by RAFT Emulsion Polymerization

Synthesis of Ultra-High molecular weight polyethylene elastomers by para-tert-Butyl dibenzhydryl functionalized α-Diimine nickel catalysts at elevated temperature

Synthesis of low-entangled UHMWiPP using Hf-pyridyl amido catalyst activated by trityl tetrakis (pentafluorophenyl) borate

Weakly Entangled Ultrahigh Molecular Weight Polyethylene Prepared via Ethylene Extrusion Polymerization

Study of the effect of the nature of catalyst systems on the molecular structure and properties of ultra-high molecular weight polyethylene

Reduced Entanglement Density of Ultrahigh-Molecular-Weight Polyethylene Favored by the Isolated Immobilization on the MgCl2 (110) Plane

Easy Access to Ultrahigh-Molecular Weight Poly(1,3-dioxolane) by Rare Earth Triflates

A Novel Catalytic System of [O,O] Bidentate Titanium Complexes and Et2AlCl/Bu2Mg for the Production of Ultra‐High Molecular Weight Polyethylene

Facile high-temperature synthesis of weakly entangled polyethylene using a highly activated Ziegler-Natta catalyst