Abstract:A strain-insensitive temperature sensor based on multimode interference using standard multimode fibers (MMFs) is proposed according to the comprehensive study of the characteristics of the MMFs. The temperature and strain dependences on the core diameter, numerical aperture (NA), and the length of the MMF section in the single-mode--multimode--single-mode (SMS) fiber structure are investigated experimentally. The results indicate that the larger core diameter of the MMF leads to higher temperature sensitivity but lower strain sensitivity (absolute values); the higher NA does not influence the temperature sensitivity but results in higher absolute value of strain sensitivity; the longer MMF section brings lower temperature sensitivity but does not have an impact on strain sensitivity. These findings also contribute to the theoretical analysis of the length dependence in the SMS fiber sensors. Besides, the results of the characterization study show that the strain sensitivity is relatively low, which brings a possibility to develop a strain-insensitive temperature sensor. The proposed sensor is used for temperature sensing while the strain is constantly applied from 0 to 1100 $\mu\epsilon$ with steps of 100 $\mu\epsilon$. The measured results are consistent with the comprehensive study. The mean temperature sensitivity is 6.14 pm/$^{\circ}$C with a standard deviation of 0.39 pm/$^{\circ}$C, which proves that the proposed temperature sensor exhibits good stability and is insensitive to strain. We expect that these results will provide a profound guideline to fiber sensors based on multimode interference.

Fiber-optic temperature sensing using Raman spectrum near Rayleigh peak

Fiber temperature sensor based on rare earth fluorescence material

High-resolution Temperature Fiber Ring Laser Sensor Based on Relative Intensity Noise Measurement

Enhanced Raman Distributed Temperature Sensor Using a High Raman Gain Fiber

Optical Temperature Sensor Based On Zno Thin Film'S Temperature-Dependent Optical Properties

Physics and applications of Raman distributed optical fiber sensing

Yb,Er,Tm:Sc2O3 Single Crystal Fibers for Multi-Mode Optical Thermometry

Performance evaluation of Raman scattering-based distributed optical fiber temperature sensing system in cryogenic environment

Distributed fiber optic temperature sensor based on dynamic calibration of Raman Stokes backscattering light intensity

Fiber Raman Distributed Temperature Sensor Based on the Light Source with Adjustable Pulsewidth

Evaluation of Fiber Optic Raman Scattering Distributed Temperature Sensor Between –196 and 400 °C

Research of Distributed Optical Fiber Temperature Measurement System Based on Raman Scattering Principle

Resonant fiber-optic thermometry with high resolution and wide range

High-Resolution and Large-Dynamic Range Fiber-Optic Sensors Based on Dual-Mode Direct Spectrum Interrogation Method

High-Resolution Strain and Temperature Sensor Based on Distributed Bragg Reflector Fiber Laser

Distributed Temperature and Curvature Sensing Based on Raman Scattering in Few-Mode Fiber

Fiber-optic multimode interference sensing: comprehensive characterization and its potential for strain-insensitive temperature sensing

Refractive index sensing with temperature compensation by a multimode-interference fiber-based optical frequency comb sensing cavity

Advanced Fiber Optic Sensing for Cryogenic Simultaneous Temperature and Strain Measurement

High-speed and high-resolution YAG fiber based distributed high temperature sensing system empowered by a 2D image restoration algorithm

Fiber-optic temperature sensing probe using low-coherence light source