Abstract:Filled rubber has been extensively used in the repairing, retrofitting, and protecting of civil infrastructures due to its superior physical and mechanical properties. However, effects of large deformation and velocity impacts on the mechanical behavior of filled rubber are not well recognized, one of the major challenges in the past investigations is that the material exhibits significant nonlinearity and sensitivity to velocity. This paper presents a hyper-viscoelastic constitutive modeling and experimental study to capture both the hyperelastic and viscoelastic behaviors of filled rubber under large shear deformation and velocity impacts. Motivated by the micro-mechanism of filled rubber, the constitutive modeling consists of an equilibrium element in parallel with an improved Maxwell element to incorporate both nonlinear hyperelasticity and rate-dependent performance governed by the readjustment and rearrangement of molecular chains in the material. A new strain energy function is developed and the physical description of parameters in the strain energy function is highlighted. The Clausius-Duhem inequality is employed to consider the thermodynamic consistency of the model. Then, stress relaxation property and stress-strain response of filled rubber upon cyclic shear loading with different strain rates (ranging from 0.08 to 12.0 s−1) are experimentally studied, and some key observations are summarized. Subsequently, a “Gau-Poly” function is proposed based on the experimental data to describe the viscoelastic property of filled rubber versus strain and strain rate. Finally, stress-strain relationship and hysteretic area obtained from the experimental results were compared with the numerical results of the model, good agreement was achieved and the capacity of the model to accurately reproduce the mechanical behavior of filled rubber under a wide range of deformation and velocity impacts was verified.

An innovative tensile test method to evaluate the effect of the loading rate on viscoelastic interfaces

Effect of the loading rate on viscoelastic interfaces with bridging fibers

Viscoelastic Bilinear Cohesive Model and Parameter Identification for Failure Analysis of Adhesive Composite Joints

Experimental and Numerical Studies on the Loading Rate Dependent Tensile Behavior of Carbon Fiber/epoxy Interfaces

Experimental and numerical study on the loading rate dependent tensile behavior of carbon fiber/epoxy interface

Hyperelastic Behavior of Two Rubber Materials under Quasistatic and Dynamic Compressive Loadings - Testing, Modeling and Application

Influence of Loading Rate on the Cohesive Traction for Soft, Rubber-like Adhesive Layers Loaded in Modes I and III

Cohesive zone modeling for viscoplastic behavior at finite deformations

A novel viscoelastroplastic constitutive model of rubber materials and parameter identification

Tension Testing of Silicone Rubber at High Strain Rates

Experimental Investigation and Constitutive Modeling of Uncured Carbon Black Filled Rubber at Different Strain Rates

Effects of Large Deformation and Velocity Impacts on the Mechanical Behavior of Filled Rubber: Microstructure-Based Constitutive Modeling and Mechanical Testing

Tension responses of carbon black filled rubbers at intermediate and high strain rates: Experimental investigation and modeling

A rate-dependent cohesive zone model with the effects of interfacial viscoelasticity and progressive damage

On the Development of New Test Techniques to Measure the Tensile Response of Materials at High and Ultra-high Strain Rates

Numerical simulation and experimental verification of heat build-up for rubber compounds

Study on the optimal loading rates in the measurement of viscoelastic properties of hydrogels by conical indentation

Loading Rate Effect on the Shear Behavior of the Carbon Fiber/epoxy Interface

Constitutive model and its application for rubber material based on Exp-ln model and generalized viscoelastic theory

Designing the Cross-Linked Network to Tailor the Mechanical Fracture of Elastomeric Polymer Materials

Experimental studies on the interfacial separation and stiffness of rough elastic-plastic solids