Abstract:Achieving a viable process for three-dimensional (3D) printing of ceramics is a sought-after goal in a wide range of fields including electronics and sensors for harsh environments, microelectromechanical devices, energy storage materials, and structural materials, among others. Low laser absorption of ceramic powders renders available additive manufacturing (AM) technologies for metals not suitable for ceramics. Polymer solutions that can be converted to ceramics (preceramic polymers) offer a unique opportunity to 3D-print ceramics; however, due to the low viscosity of these polymers, so far, their 3D printing has only been possible by combining them with specialized light-sensitive agents and subsequently cross-linking them layer by layer by rastering an optical beam. The slow rate, lack of scalability to large specimens, and specialized chemistry requirements of this optical process are fundamental limitations. Here, we demonstrate 3D printing of ceramics enabled by dispensing the preceramic polymer at the tip of a moving nozzle into a gel that can reversibly switch between fluid and solid states, and subsequently thermally cross-linking the entire printed part "at-once" while still inside the same gel. The solid gel, which is composed of mineral oil and silica nanoparticles, converts to fluid at the tip of the moving nozzle, allows the polymer solution to be dispensed, and quickly returns to a solid state to maintain the geometry of the printed polymer both during printing and the subsequent high-temperature (160 °C) cross-linking. We retrieve the cross-linked part from the gel and convert it to ceramic by high-temperature pyrolysis. This scalable process opens up new opportunities for low-cost and high-speed production of complex three-dimensional ceramic parts and will be widely used for high temperature and corrosive environment applications, including electronics and sensors, microelectromechanical systems, energy and structural applications.

3D gel printing of alumina ceramics followed by efficient multi-step liquid desiccant drying

3D printing of ceramics with controllable green‐body configuration assisted by the polyvinyl alcohol‐based physical gels

Fabrication of porous aluminum ceramics beyond device resolution via stereolithography 3D printing

Optimization of 3D Printing Parameters for Alumina Ceramic Based on the Orthogonal Test

Effect of particle size distribution and printing parameters on alumina ceramics prepared by Additive Manufacturing

Enhanced mechanical properties of 3D printed alumina ceramics by using sintering aids

Three-Dimensional Printing of Ceramics through "Carving" a Gel and "Filling in" the Precursor Polymer

Preparation of high performance dense Al 2 O 3 ceramics by digital light processing 3D printing technology

Fabrication of alumina ceramics with high flexural strength using stereolithography

Fabrication and properties of alumina ceramics shaped by digital light processing as an additive manufacturing technology

3D printing of high solid Al2O3 ceramics based on green and renewable photosensitive resin with low viscosity and low shrinkage

Preparation of ZTA composite ceramics derived from sol–gel method by DIW printing

Preparation of large-size alumina ceramic parts by DLP 3D printing using high-solid-loading paste and optimizing the debinding process

Large-size Si 3 N 4 ceramic fabricated by additive manufacturing using long-term stable hydrogel-based suspensions

Study of alumina ceramic parts fabricated via DLP stereolithography using powders with different sizes and morphologies

Tunable Size of Hierarchically Porous Alumina Ceramics Based on DIW 3D Printing Supramolecular Gel

Alumina Ceramics for Armor Protection via 3D Printing Using Different Monomers

Reinforcement effect in printing precision and sintering performance for liquid crystal display stereolithography additive manufacturing of alumina ceramics

Rheological behavior and curing deformation of paste containing 85 wt% Al2O3 ceramic during SLA-3D printing

Extrusion-Based 3D Printing for Highly Porous Alginate Materials Production

Effect of different sintering additives type on Vat photopolymerization 3D printing of Al2O3 ceramics