Investigation of the catalyst ink compositions for a uniform microporous catalyst layer preparation via electrospray deposition technique and MEA assembling conditions in PEMFC specific

Christian Ayuste,Vo Dinh Cong Tinh,Anima B. Bose

DOI: https://doi.org/10.1016/j.ssi.2023.116452

IF: 3.699

2024-02-01

Solid State Ionics

Abstract:High utilization of catalyst and preserving evenly distributed pores for Proton Exchange Membrane Fuel Cell (PEMFC) electrodes were optimized using an in-house designed electrospray system. In order to hold the porous electrode structure prepared through the electrospray technique by varying ink compositions. Using optimized electrodes and commercially available Nafion-212 membrane, a series of membrane-electrode assemblies (MEAs) were fabricated by varying the hot-pressing parameters of pressure, temperature, and time for evaluating the performance at 60 °C to 80 °C with varying relative humidity. The MEAs were hot-pressed at 8 MPa for 390 s at a temperature of 150 °C generating a maximum peak power density of 903 mW cm−2 and current density of 1040 mA cm−2 at 0.6 V and calculated electrochemical surface area (ECSA) is 23.96 m2/gPt. In contrast, the MEAs hot-pressed for the same length of time at the same temperature but with a lower pressure of 2.67 MPa generated higher peak power density of 1130 mW cm−2, higher current density of 1320 mA cm−2 at 0.6 V, despite having a lower ECSA of 19.18 m2/gPt. Overall, results in this study present that low hot-pressing pressure and a high pressing temperature enable a negative effect on the porous structure of electrospray electrodes for producing the high achievement of MEA performance.

chemistry, physical,physics, condensed matter